JLL IC100 PRO Manual

INSTRUCTION GUIDE
IC100 PRO MONITOR

The contents of this manual are subject to change without notice to improve quality.
© 2023 JLL Fitness Ltd
JLL Fitness Ltd owns the copyright for this manual.
Use or reproduction of this manual in parts or entirety without the authorization of JLL Fitness Ltd is prohibited.
COPYRIGHT

CONTENTS
- Safety precautions
- Cleaning
- Installation
- Operation
Exiting scan mode
Resetting your monitor
- Data readouts
- Troubleshoot
- Contact details
p. 4
p. 5
p. 6
p. 7
p. 7
p. 7
p. 8
p. 9
p. 10

4
SAFETY PRECAUTIONS
The monitor on this machine has been tested to the required standards, each of those passed regulations are shown via
the following symbols:
WEEE - Waste Electrical and Electronic Equipment Recycling.
ABS - Acrylonitrile Butadiene Styrene often referred to as ABS is a type of plastic that is an opaque thermoplastic.
CE - The product conforms with relevant EU directives regarding health and safety or environmental protection.
QC Pass - A product which has fullled the requirements of a technical control and passed the outgoing exams.
ROHS - This is an abbreviation for “Restriction of (the use of certain) Hazardous Substances in electrical and electronic
Equipment”.
WEEE Symbol
ABS Recycling Symbol
EU Compliance Symbol
Quality Control Symbol
ROHS Symbol

5
CLEANING
Please take care when cleaning this monitor as the LCD screen can easily be scratched.
You will need a soft dry cloth
Do not spray cleaning chemicals directly onto the monitor
Do not apply water to the monitor as it is electrical and may damage the internal components

6
INSTALLATION
STEP 1 STEP 2
STEP 3 STEP 4
Insert the batteries, making sure they are the
correct way round.
Remove the four screws already in the back of
the monitor.
Connect the male to female wires from the base
to the monitor.
Secure the monitor to the frame using the four
screws removed previously.

7
OPERATION
The IC100 Pro monitor has a total of 4 readouts, displaying:
Time Speed Distance Calories
When rst powered on, the monitor will automatically be in ‘Scan’ mode. This means the digits on the screen will change
every few seconds between time, distance, speed etc. This will allow you to have an overview while training without
pressing any buttons.
EXITING SCAN MODE
On this monitor there is only one button, press this to exit scan
mode and continuously press it to view each readout.
RESETTING YOUR MONITOR
To reset all of the readings to zero, press and hold the button for
a few seconds. You will then see the digits ash zero’s and the
monitor will beep.

8
DATA READOUTS
Readout Measurement
Time Minutes : Seconds
Speed MPH
Distance Miles

9
TROUBLESHOOT
Issue Resolutions
No power to the monitor • Make sure the batteries are fully inserted
and the correct way round.
• Check your connection wires from the
monitor to the base. They must not be
trapped, fully connected and the pins
must be straight.
No pulse reading • Make sure the pulse plates are clean and
dry.
• Do not have any lotion on your hands.
• Sweat can affect the reading.
• Make sure both hands are fully gripping
each plate.

10
CONTACT DETAILS
Tel: [phone]
Email: info@jlltness.co.uk
Live Chat: WWW.JLLFITNESS.CO.UK

11

@JLLFITNESS