JLL R200 Manual

INSTRUCTION GUIDE
R200 MONITOR

The contents of this manual are subject to change without notice to improve quality.
© 2023 JLL Fitness Ltd
JLL Fitness Ltd owns the copyright for this manual.
Use or reproduction of this manual in parts or entirety without the authorization of JLL Fitness Ltd is prohibited.
COPYRIGHT

CONTENTS
- Safety precautions
- Cleaning
- Replacing the batteries
- Operation
View each readout
Resetting your monitor
- Data readouts
- Troubleshoot
- Contact details
p. 4
p. 5
p. 6
p. 7
p. 7
p. 7
p. 8
p. 9
p. 10

4
The monitor on this machine has been tested to the required standards, each of those passed regulations are shown via
the following symbols:
ROHS - This is an abbreviation for “Restriction of (the use of certain) Hazardous Substances in electrical and electronic
Equipment”.
QC Pass - A product which has fullled the requirements of a technical control and passed the outgoing exams.
SAFETY PRECAUTIONS
ROHS Symbol Quality Control Symbol

5
CLEANING
Please take care when cleaning this monitor as the LCD screen can easily be scratched.
You will need a soft dry cloth
Do not spray cleaning chemicals directly onto the monitor
Do not apply water to the monitor as it is electrical and may damage the internal components

6
REPLACING THE BATTERIES
STEP 1 STEP 2
STEP 3 STEP 4
Press the small clip under the monitor to release
it from the base.
Remove the old batteries.
Insert the new batteries the correct way round. Press the monitor back into the base.

7
OPERATION
The R200 monitor has a total of 6 readouts, displaying:
Total Count, Calories, Count/Min, Count, Distance and Time
When rst powered on, the monitor will automatically be in ‘Scan’ mode. This means the digits on the screen will change
every few seconds between time, distance, count etc. This will allow you to have an overview while training without
pressing any buttons.
VIEW EACH READOUT
The R200 has a single button, press this once to exit ‘Scan’ mode.
Continuously press this button to scroll through each readout, small
black arrows on each side will indicate which readout is currently
visible.
RESETTING YOUR MONITOR
To reset your monitor back to zero, press and hold the single
button. All the digits will then ash and the monitor will beep.

8
DATA READOUTS
Readout Measurement
Time Minutes : Seconds
Count 0 - 999
Distance Kilometres
Total Count 0 - 999
Count/Min Average number of strokes per minute

9
TROUBLESHOOT
Issue Resolutions
No power to the monitor • Make sure the batteries are fully inserted
and the correct way round.
• Check your connection wires from the
monitor to the base. They must not be
trapped, fully connected and the pins
must be straight.
Power on but the digits aren’t changing • Check the small black square sensor
on the underside of the slideway is
attached securely and undamaged.
• If this is the case and no readings are
still not showing on the screen please
use a generic magnet (e.g. fridge
magnet) and move it over the sensor.
If the digits change you may require a
new saddle. If not you may require a
replacement sensor.

10
CONTACT DETAILS
Tel: [phone]
Email: info@jlltness.co.uk
Live Chat: WWW.JLLFITNESS.CO.UK

11

@JLLFITNESS