Kaba Ilco 790/79 Series User manual

PK3612_07_12
IMPORTANT: Wear Safety glasses before starting the replacement of parts.
790/79 Series Rework Installation Sheet
Current PCB
Switch
Holder
New
Cam
Protective
Bracket
New privacy
Switch
New PCB
1
4 6
A
B
C
D
5
2 3
Remove screw and take out battery pack
Remove foam, cam & screws and discon-
nect cables
Assemble New PCB
Option
Option
Option
Motor (See step 4)
Pass cables in
housing gap push
cables away from
the screw head
Place the plastic clip to hold the cables in place. Make sure
the clip is not on the cables before to hold it with the screw
Before placing PCB connect
standard cables and cables
for door option if applicable
at orientation as shown
Use screws from step 4
Override Switch
(See step 4)
Remove PCB
Remove 5 screws and take off the back
plate Assemble protective bracket and hold with one of the 5 screws from step 2
Screw below center label
Protective Bracket
790/79 Series LOCK PCB + PRIVACY MECH. PARTS

1.877.468.3555
www.ilcosupport.com
7
10 11
12 13
8 9
Connect privacy switch to PCB. Location
as shown
Assemble new cam. Move switch lever
(see arrow) first and assemble cam after
Remove protective bracket
Assemble back plate with 5 screws Assemble battery pack with screw
Assemble the switch holder, pass the wires
underneath it. Make sure the screw head is
underneath as shown.
Assemble privacy switch on switch holder
Switch lever orientation
Screw Head
Place Cam
orientation as shown
Align cam &
back plate
Pass cables
through back
plate hole
Side contact
Be careful that the spring does not jump and is still in its position
5X
Align marks
790/79 Series Rework Installation Sheet
PK3612_07_12