KI Rapture Stack Chair User manual

There are two No Arm Back Clips locate on the backrest of the chair. If you were sitting
in the chair, rotate the clip to the right clockwise and the clip to the left counterclockwise.
Pull the backrest up away from the frame and seat assembly. The clips may fall out when
the backrest comes off the frame. If upholstery pad needs to be change over to the new
poly back, go to frame 3. If upholstery pad don’t have to be changed over to the new
poly back, go to frame 5.
To replace the upholstery pad on the poly back, four screws that are located on the
opposite end of the pad must be taken out. Separate the upholstered pad from the poly
back. Fetch the new poly back and align the screw holes of the poly back to the threaded
holes on the upholstery pad. Replace the four screws on back of poly back.
Location of
Chair Back
Clips
1
2
3
4
Poly Back
Upholstered
Pad Back
Remove the Four
Screws

Fetch the new backrest that will be assembled on the existing frame and seat assembly.
Slide the backrest down onto the frame until the frame tubing comes up to the bottom of
the clip cutout positions on the back. Put the No Arm Back Clips into the backrest cutout
area. The clips are marked with an R and L. If you were sitting in the chair, the clip
marked with an R goes to the right side and the clip marked with an L goes to the left side
on the backrest. Place the clips in their position with the R and L marks facing out
towards you. Slide the backrest and clips down onto the frame.
When the backrest has been pushed in all the way down onto the frame back tubes, rotate
the clip marked L clockwise and the clip marked R counterclockwise. The clips will not
rotate if the backrest is not pushed all the way down onto the frames back tubes.
Clip Positions
Push the backrest
down when clips
are in position
The backrest must
be pushed all the
way down onto the
back tubes on the
frame for the clips
to rotate.
5
6