KI KI 700 Series User manual

Assembly Instructions
KI 700 Series Pedestal (shown)
September 1997
KI Pembroke
P.O. Box 580
1000 Olympic Drive
Pembroke, Ontario
K8A 6X7
TEL [phone]
FAX [phone]
E-Series Pedestal/Areus Pedestal/Systems Wall Pedestal
Mounting Hanging/Worksurface
Supporting Pedestal to Worksurface
Method “A”
1. To avoid scratching the worksurface, place face
down on a protective surface.
2. Determine on which side will be used.
3. Install (4) hanger bolts into the 13/64” dia.
holes. CAUTION: Do not over tighten.
4. Position back of pedestal to engage with back
hanger bolts and slide backward enough to
allow front key slots to engage.
5. Install thumb screw through pedestal top and
into predrilled hole in the worksurface. Thumb
screw must be installed to lock pedestal to the
worksurface (Detail A).
Method “B”
NOTE: For hole locations on unmarked tops, refer to
reverse side.
1. This method should be used only when
attaching a pedestal to worksurface that cannot
be placed face down on the floor.
2. Follow instructions in Method “A” excluding
step 1.
CAUTION: To avoid injury this operation requires
more than one person to install pedestal.
Method “A”
Hanger Bolt
Worksurface
Pedestal
Method “B”
Worksurface
Hanger Bolt
Pedestal
Predrilled Hole
Thumb Screw
Detail A

Drill Hole Locations on Unmarked
Worksurfaces
NOTE: All vertical dimensions assume pedestal
to be mounted 1/16” back from front
edge of worksurface.
NOTE: All holes except as noted
3/16” dia. x 3/8” deep. Assumes use
of supplied screws drilled into 1 1/4”
particleboard or equivalent.
Mobile Pedestal Caster Installation
1. Four casters are provided (five if
applicable) for installation into the base of the
pedestal. Four similarly sized casters
should be installed in the cabinet; and if
applicable the smaller caster should be
installed into the drawer body.
2. The four large casters should be threaded
into the inner hole of each weld nut. The
two locking type casters should be
installed at the front of the unit; the two
non- locking type casters at the back of the
unit. Thread the caster shank fully into
the weld nut. The shoulder of the shank
should be flush with the weld nut.
3. If applicable, extend the bottom drawer
slightly to expose the caster mount.
Thread the small anti-tip caster shank fully
into the weld nut on the bottom of the
drawer body. The shoulder of the caster
shank should be flush with the weld nut.
Part # 21150-1
Pedestal
Anti-tip Caster
Locking Casters
Non-Locking Casters
CAUTION
Assemble units as described herein only. To do
otherwise may result in instability. All screws,
nuts and bolts must be tightened securely and
must be checked periodically after assembly.
Failure to assemble properly, or to secure parts
may result in assembly failure and injury.