KI 700 Series User manual

AssemblyInstructions
KI700SeriesCredenzaShell
August1997
KI Pembroke
P.O. Box 580
1000 Olympic Drive
Pembroke, Ontario
K8A 6X7
TEL [phone]
FAX [phone]
2
1
3
2
4
Tools Required
ŸPhillips Screwdriver
Ÿ3/8” Socket/Wrench
Components
1 - Worksurface
2 - End Panel
3 - Modesty Panel (Full/Partial)
4 - Wire Management Channel
Hardware Parts List
(12) #20162 - #8 x 1/2” Screws
(4) #20201 - #14 x 7/8 Hanger Screws
(4) #20425 - Hex Glides
Down
Key Hole
Worksurface
Hanger Screw
Detail A
Wire Management
Channel Desk End
Panel
Worksurface
Detail B
1. To avoid scratching worksurface,
place face down on a protective
surface.
2. Insert (2) hanger screws in predrilled
holes for end panels. Place end panel
over hanger screws and slide into
position (Detail A). Repeat for
opposite end.
3. Position modesty panel between end
panels, aligning holes with those in
end panels, fasten using (3-4)*
#8 x 1/2” screws in both ends.
4. Place wire management channel
between end panels, product label
facing inward, align holes with
predrilled holes in worksurface. Bend
tabs in end panel over wire
management channel (Detail B).
Secure channel in place using (3)
#8 x 1/2 screws.
5. If attaching bridge/return, align level
connector (shipped with
bridge/return) with predrilled holes in
worksurface. Use (2) #14 x 7/8”
screws to attach level connector to
worksurface.
6. Screw (4) hex glides in bottom of end
panels. See options on reverse.
*(3) - #8 x 1/2” screws - partial
modesty panel
(4) - #8 x 1/2” screws - full modesty
panel

Worksurface
Hanger Screw
Pedestal
Mounting Pedestal to Worksurface
Mounting hardware included with
pedestal.
1. Determine on which side the pedestal
will be used.
Predrilled Hole
Thumb Screw
Detail A
2. Install (4) hanger screws into 13/64”
dia. holes. CAUTION: Do not over
tighten.
3. Position back of pedestal to engage
with back hanger screws and slide
backward enough to allow front key
slots to engage. Continue to push
backward until full engagement is
reached.
4. Open top drawer, install thumb screw
through pedestal top and into
predrilled hole in the worksurface.
Thumb screw must be installed to
lock pedestal to the worksurface
(Detail A).
21180-2 Jan.1998
CAUTION
Assemble units as described herein only. To do otherwise may result in instability. All screws, nuts and bolts must
be tightened securely and must be checked periodically after assembly. Failure to assemble properly, or to secure
parts may result in assembly failure and injury.
13/64” dia. Hole
Attaching Return/Bridge to Desk
1. Arrange desk return/bridge modesty
panel with holes in flange aligned
with holes in end panel of desk shell.
Fasten with (4) #8 x 1/2” screws.
2. Connect desk return/bridge to
connector with (3) #14 x 7/8”
screws using predrilled holes in
return/bridge top.
Credenza Shell
Level Connector (Incl.
with Return/Bridge)
Return/Bridge