Deriving maximum
benefit from your
Impress Ultra
Task chair
To benefit from the Impress Ultra chair’s
range of ergonomic features, individual
adjustments need to be made.
Proper cardiovascular circulation
requires the seat be at the correct
height. With feet flat on the floor.
Seat height is adjusted with a pneumatic
cylinder. To lower height while seated,
lift the lever at the right front of the seat.
To raise the height, remove your weight
from the seat while lifting the lever.
Adjust the back height by grasping the
back with both hands. In either a seated
or standing position, raise or lower the
back to the desired height. To lower the
back, first raise it to its highest position.
(Available on midback model only).
To lock the back in one of three angles,
move back to the desired position.
Then push in the lever at the
right rear of the seat.
To return the back
to its free-floating
position, pull out
the lever.
To adjust seat
depth, raise the
lever at the left
front of the seat.
Care of your
Impress Ultra
Task Chair
Care of your Impress Ultra task chair is
easy.
It requires no more care than any other
fine seating. Exclusive functional
mechanisms and component integrity
are thoroughly tested. A ten-year
warranty covers structural integrity,
while a one-year warranty covers
upholstery.
Periodic light cleaning is all that is
necessary. Be certain to vacuum
upholstery frequently and thoroughly.
Use mild soap or detergent with luke-
warm water and a soft, non-scratching
cloth to clean plastic surfaces,
upholstery, and powder-coated metal.
Stains and spots may require a more
thorough cleaning. For this we
recommend:
Fabric Upholstery --Use a
foam-type cleaner such as Johnson Wax
“Glory” or Earl Grissmer Co. “Blue
Lustre” for general cleaning.
For more stubborn spots and stains, use
Texie Chemical Co.’s “K2r”. Always fol-
low the manufacturer’s directions.
Plastic parts and powder-coated
finishes - Chewing gum and similar
stubborn spots may be removed with
cigarette lighter fluid. Wipe dry
immediately. Sunnyside Plastic Cleaner
is ideal for light cleaning. Buffing with
this product restores luster to smooth
surfaces. Its anti-static properties help
repel dust and dirt. High quality wax,
such as Johnson’s “Glo-Coat” or
“Simonize”, restores luster and protects
the finish. Follow container directions
and apply with a soft cloth and buff
thoroughly.
Caution: Do not use dry cleaning
agents on upholstery, or a coarse cloth
when applying cleaning agents to
smooth surfaces.
Arms --If your chair has arms, the
fasteners attaching the arms to the
underside of the seat should be
periodically tightened.
height and width
adjustable arms
back lock
seat height
adjustment
seat depth
adjustment
tilt tension
Then, slide forward or back to the
desired position and release the lever.
Seat tilt tension knob is located directly
under the front of the seat. To increase
tension turn the dial clockwise. To decrease
tension, turn the dial counter-clockwise.
Adjustable “T” Arm: To adjust arm
height, pull up on the lever on the
outside of the arm. To adjust arm
width, push up on the small tab
underneath the arm and move the
arm inward or outward.
Adjustable Loop Arm: To adjust arm
height, turn the dial on the outside of the
arm. To adjust width, loosen hardware
under the arm, reposition and retighten.
Pivoting “T” Arm: To adjust arm height,
pull up on the lever on the outside of
the arm. To change the angle of the
armcap, pull up on the armcap and turn
to the desired angle, and
release the armcap. To
adjust arm width, push
up on the small tab
underneath the arm
and move the arm
inward or outward.
