Kichler Lighting Golden Iridescence User manual

Golden IridescenceTM
Kichler®Lighting
7711 East Pleasant Valley Road
P.O. Box 318010
Cleveland, Ohio 44131-8010
Customer Service
866.558.5706
8:30 AM to 5:00 PM EST,
Monday - Friday
A Kichler®Décor™ceiling fan
Designed to coordinate with a popular Kichler Lighting collection.
Instruction Manual

1
1. SAFETY RULES
WARNING! RISK OF ELECTRIC SHOCK
"CAUTION-RISK OF FIRE"
CONSULT A QUALIFIED ELECTRICIAN TO
ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
Fig. 1
Fig. 2
2. INSTALLING THE LIGHT KIT
All electrical connections must be in accordance
with local codes, ordinances, or national codes. If
you are unfamiliar with methods of installing electri-
cal wiring, secure the services of a qualified
electrician.Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse block. Turning power off
using fan switch (speed control on/off) is not suffi-
cient to prevent electrical shock.
NOTE: The important safeguards and instructions
appearing in this manual are not meant to cover all
possible conditions and situations that may occur.
It must be understood that common sense, cau-
tion and care are factors which cannot be built into
any product. These factors must be supplied by
the person (s) caring for and operating the unit.
1. Take the fixture out of the box and packing
foam. Remove the Switch Housing cover from
your Ceiling Fan. Remove the decorative plate,
decorative ball and finial from it. Thread the Light
Fixture into the hole in the center of the Switch
Housing cover. On the inside of the Switch Hous-
ing cover, add a lock washer and nut to the Light
Fixture and tighten. (Fig. 1)
Note: All screws must be checked and retight-
ened where necessary.
Switch housing cover
Light kit
Nut
Lock washer
Switch housing
cover
Light kit
Mounting plate
Plastic nut
Black wire
Black wire
White wire
White wire
AMP connector
2. You can find total 4 pcs plastic nuts preinstalled
on the end of the black and white wires coming
from the switch housing cover and light fixture.
Remove the plastic nuts first, and twist the bare
section of same color wires into one body, then
place the plastic nut on it. Finally match up the
color on the side of the connector and push them
together until the snap engages. (Fig. 2)

2
Golden IridescenceTM
1. Install 3 x 60W bulbs (not included) .
(Fig 4)
3. Restore power only after installation is
completed.
2. INSTALLING THE LIGHT BULBS &
GLASS SHADE
Fig. 
Fig. 
2. Place glass shade over the light kit stem,
secure with the metal nut(rubber side on the top),
decorative plate, decorative ball and finial. (Fig 4)
3. Carefully push all of the wires into the Switch
Housing. Align the keyholes on the light fixture
with the screws on the mounting plate. Turn the
light fixture counterclockwise and tighten all
three screws. (Fig 3)
Light kit
Screw
Finial
Decorative ball
Manual nut
Silicon washer
Metal washer
Bulb