Kimball Office Aspire User manual

Tables Assembly Instructions
Aspire®
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1699156 Revision C-03
Page 1 of 2
Unfold 4-Piece Folding Tables
Tools Required
■Utility Knife ■#3 Allen Wrench
Package Contents
■4-piece Folding Table
Installation
1. Position folded table in desired location. Cut all plastic ties
from table frame, springs, and undersurface cabling.
(Figure A).
2. To unfold table, open only one section of the table at a time.
Pull outward on the outer section at one end of the table.
Push down on the middle areas of the worksurfaces. Be
careful to keep hands away from pinch points. (Figure B).
Note: If both sections of the table are folded/unfolded at
the same time, the worksurfaces will be damaged.
3. Table section will stop unfolding when worksurface pieces
are horizontal. (Figure C).
4. To lock table section in position, firmly pull locking handles
out and turn handle ends away from each other so that the
handles are parallel to the bottom side of the worksurface.
Release handles to allow them to snap into the locked
position. (Figure D).
Note: Locking handles are on both sides of the table. Make
sure all handles are in the locked position before using table.
Figure A
Figure B
Lock
Pull out
Figure C Figure D
Cut plastic
ties from
cables and
springs
Cut plastic
ties from
frame

Tables Assembly Instructions
Aspire
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1699156 Revision C-03
Page 2 of 2
Installation (continued)
5. Follow Steps 2, 3, and 4 to unfold and lock the other section
of the table. (Figure E).
6. To unlock table, firmly pull locking handles out and
turn handles down until they are perpendicular to the
worksurface. Release handles, making sure they remain in
the unlocked position. Remember that locking handles are
on both sides of the table. Make sure all handles are
unlocked before folding table. (Figure F).
7. If the center area of the worksurface is uneven when the
table is in the open position, the worksurfaces can be
adjusted with set screws located under and behind the
locking handles on each side of the table. (Figure G).
8. Check worksurfaces for unevenness. (Figure H).
9. Use the #3 Allen wrench to adjust set screws up or down
until worksurfaces are flush. Adjust on both sides of table,
if necessary. (Figure I).
Figure E
Figure F
Figure IFigure H
Figure G
Printed in U.S.A. © 2003 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Unlock
Set screws
Worksurface not flush
Worksurface adjustment set screws
(two on each side of table)
Use Allen wrench
to adjust set screws
Raise or lower set screws to
achieve flush worksurfaces
(both sides of table)