Kimball Office Innsbruck User manual

Casegoods Assembly Instructions
Innsbruck/Osterley Park
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741545 Revision A-05
Page 1 of 2
Wood Shelf Removal and
Adjustment and Door Hinge
Adjustment
Tools Required
■Phillips Screwdriver
Package Contents
■None
Installation
Note: Shelves are secured in unit with shipping screws.
1. An adjustable shelf consists of a shelf and four (4) shelf
support brackets. (Figure A).
2. All cabinets feature pre-bored holes 11⁄4" apart.
Recommended spacing is #2 position as shipped, for proper
ring binder clearance. (Figure B).
3. For repositioning of shelves, the shipping screws must be
removed. (Figure C). Remove shelf and move shelf support
brackets to desired hole locations, making sure all brackets
are at the same level.
4. For additional security, adjustable shelves can be fastened
into position by reusing the #6 x 5⁄8" panhead shipping
screws.
Figure B
Figure C
Shelf
Shelf Support
Bracket
1
2
3
1
2
3
Figure A
Shelf Support
Bracket
#6 x 5⁄8" Panhead
Shipping Screw

Casegoods Assembly Instructions
Innsbruck/Osterley Park
Printed in U.S.A. © 2005 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741545 Revision A-05
Page 2 of 2
Installation (continued)
5. Side Adjustment:
Turn front screw clockwise to decrease door inset,
counterclockwise to increase inset. (Figure D).
Note: Adjust margins around doors to be equal.
6. Depth Adjustment:
Loosen back screw. Adjust door to desired position and
re-tighten screw. (Figure E).
7. Height Adjustment:
Loosen screw(s) on the mounting plate. Adjust door to
position and tighten screws. (Figure F).
8. Door Removal and Installation:
To remove, pull release lever back. (Figure G). To re-install,
place the hinge on the mounting plate and push the hinge
with finger pressure. The snap sound confirms a secure
attachment.
Figure E
Side Adjustment
Figure F
Figure G
Removal
Figure D
Height Adjustment
Depth Adjustment