Kimball Office Traditional Conference Table User manual

Page 1 of 2
Assembl Instructions
Traditional
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Pa t No. 2066780 Revision A-08
Conference Ta le Top/Bases
Tools Required
■Adjusta le Wrench ■Phillips Screwdriver
or Socket Set
Package Contents
■Ta le Top ■28 Bolts
■2 Mounting Pads ■28 Washers
■Adjusta le Glides
Caution: It is recommended that more than one person be used
to assemble and move conference tables.
Installation
1. Place the ta le top upside down on a smooth, solid
surface. Match the straight ends and align the mechanical
leveling devices. (Figure A).
2. For each leveling device, thread the olt into its opposite
racket, attach nut, and tighten firmly. (Figure B).
3. Position the two mounting pads so that the holes in the
mounting pad align with the T-nuts in the top. (Figure C).
4. After ases have een installed and ta le/ ase assem ly is
turned upright, use the leveling set screws in the leveling
devices to align straight ends of the assem ly. (Figure B).
Figure A
Figure B
Figure C
Thread olt
into nut
and tighten
Align
two-piece top
Mounting
Pad
T-nuts towards
outer edge
Washer
and Bolt
com ination
Leveling
set-screw

Assembl Instructions
Traditional
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Pa t No. 2066780 Revision A-08
Page 2 of 2
Conference Ta le Top/Bases
Installation (continued)
5. Position the ases on their mounting pads. Align the six (6)
mounting holes in each pedestal ase with the holes in each
mounting pad, the center pedestal ase will align with four
(4) holes in the mounting pads . Use six (6) olts and wash-
ers to attach each ase to the mounting pads, four (4) olts
and washers for the center pedestal ase. (Figure D).
6. Insert adjusta le glides into each ase. (Figure E).
7. Carefully turn assem led unit upright. (Figure F).
Note: Follow the same installation steps for both the panal base
and the Queen Anne base.
Figure D
Figure E
Figure F
P inted in U.S.A. © 2008 Kimball Inte national, Inc. T 800.482.1818 F 812.482.8300
Pedestal ase
mounting pad
Insert
Adjusta le
Glides