Kimball Office Footprint 6"W Wardrobe User manual

Assembly Instructions
Footprint® Page 1 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066788 Revision B-08
6"W Wardrobe
Tools Required
ILevel I“C” clamp
I3⁄16" nutdriver or socket IPhillips screwdriver
IElectric drill ISix #8 x 11⁄4" Phillips head
I1⁄8" drill bit wood screws or appropriate
fasteners
Package Contents
I6"W Wardrobe I4 plastic glide hole plugs
Description
The 6"W wardrobe is NOT freestanding and must be secured to
an adjacent casegood item or a wall. An 18"W wardrobe is used
as an example of a casegood item in these instructions
(Figure A).
Note: Hardware necessary to secure wardrobe is not provided in
the package contents.
Installation
1. Position 6"W wardrobe on desired side of adjacent
casegood or wall (Figure A).
2. Secure 6"W wardrobe to adjacent item using C-clamp(s).
Make sure side panels are flush and that there are no gaps
between the units (Figure B).
3. Level the 6"W wardrobe by using the 3⁄16" nutdriver or
socket to adjust the floor glides. When level, ensure all
glides are snug against the floor, then insert plastic glide
hole plugs (Figure B).
Figure A
Figure B
No Gaps
Both Units Flush

Assembly Instructions
Footprint® Page 2 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066788 Revision B-08
6"W Wardrobe, continued
4. Drill 1⁄8" pilot holes and attach 6"W wardrobe to casegood
item or wall with six #8 x 11⁄4" Phillips head wood screws or
appropriate fasteners.
Attaching to adjacent casegood item: It is recommended
that the wood screws go through the inside of the adjacent
casegood item and into the side panel of the 6"W
wardrobe. Screws should be evenly spaced, front to back
and top to bottom. Ensure there are no gaps between units
when screws are secured. (Figure C)
Attaching to adjacent wall: The wall material (wood stud,
concrete block, etc.) will determine the type of fastener to
use. It is recommended that six fasteners be used, evenly
spaced, side to side and top to bottom, driven through the
back panel of the wardrobe and into the wall.
5. Adjust door alignment as necessary.
Doors out of horizontal alignment (Figure E): Turn screw
labeled “A” (Figure D) clockwise or counterclockwise to
increase as necessary until door is centered on unit.
Doors out of vertical alignment (Figure F): Slightly loosen
screws labeled “B” (Figure D). Reposition door up or down
for proper alignment. Retighten screws.
Note: Vertical misalignment can also occur is unit is not level.
Doors out of alignment with the side panel of unit
(Figure G): Slightly loosen screw labeled “C” (Figure D).
Reposition door. Retighten screw.
Figure C
Figure D
Figure E Figure F
Figure G
Door
Side Panel
of Unit
Door
Side Panel
of Unit
Door
Topof
Unit
Doorin Open Position Inside Panel
Screw ìA ”
Screw “B”
Screw “C”
Dislodge Tab
Screw “B”
No Gaps
Printed in U.S.A. © 2008 Kimball International, Inc. T 800.482.1818 F 812.482.8300