Kimball Office Fundamental LF Series User manual

Assembly Instructions
Fundamental®, LF Series®
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Pa t No. 2242720 Revision B-10
age 1 of 2
General Setup
Tools Required
■Flat Head Screwdriver ■hillips Head Screwdriver
■Hammer and unch ■Level
■#8-32 ³⁄₈" Hex Socket Nut Driver
General Information
• These instructions provide the basic information to do the
following in any Fundamental, LF Series:
remove and reinstall drawers, and gang units.
• Fundamental ADA File only: Screw-on pulls are packaged
inside drawer to prevent damage. Assemble using hardware
provided.
• One person can perform all operations although two may
be required to position larger units.
Installation
Removing Drawers
1. Fully extend drawer (Figure A).
2. While gripping and lifting near the top edge of the
drawer side, hand strike the drawer side just above the
extended slide to release the front locking tab (Figure A).
3. Repeat this procedure at the rear of the drawer side.
4. Support the released end of the drawer with one hand
placed beneath the drawer center.
5. Strike the opposite drawer side to release each of the
locking tabs.
6. Lift drawer from slides.
Figure A
Front
Locking Tab
Rear
Locking Tab

Assembly Instructions
Fundamental®, LF Series®
P inted in U.S.A. © 2010 Kimball Inte national, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Pa t No. 2242720 Revision B-10
age 2 of 2
Installation (continued)
Leveling Cabinet / Adjusting Glides
LEVELING IS CRITICAL. ALL FILES MUST BE LEVELED.
• Bottom drawer must be removed.
• If file is heavily loaded, it may be necessary to remove
additional drawers in order to adjust glides accurately.
1. Locate the four glides at each inside corner of the cabinet
(Figure B).
2. With level on top of cabinet, adjust glides by inserting flat
head screwdriver into glide cutout (Figure B). Turn screw
driver clockwise to raise cabinet; turn counter-clockwise to
lower cabinet.
Ganging Units
• Top drawers must be removed to provide access to inside of
cabinet.
• Units must be the same height.
• Knockouts are provided along top sides (one) of file.
1. Using hammer and punch, remove appropriate knock-outs
from the outside in.
2. Bolt together through knock-outs (Figure C). Hardware not
provided.
Reinstalling Drawers
Replace drawer by reversing procedure in “Removing Drawers.”
1. Fully extend slide from cabinet.
2. Align vertical tabs at front and rear with horizontal slot in
slide and move front of drawer down until both locking tabs
snap in place (see Figure D).
Figure B
Figure C
Figure D
Locking
Tabs
Glide
Locations