Kimball Office Casegoods President User manual

Casegoods Assembly Instr ctions
President/ enator
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741567 Revisio F-09
Page 1 of 2
Bridge Unit
Tools Req ired
■Level ■crew Gun
■Tape Measure ■Drill Bits
■#2 Phillips Head Bit
Package Contents
■4 Flat Brackets ■44 #10 x 1" Panhead crews
■2 Align-n-lock Fasteners ■4 #8 x 5⁄8" Panhead crews
■4 Hinges
Installation
1. The hinged modesty/bridge unit arrives un-assembled in
a carton. Place the bridge face down on a smooth, hard
surface. Take care to not mar the worksurface. (Figure A).
2. The bridge and modesty panel have pre-drilled holes used
to attach the two units together with supplied hinges. Attach
the hinge to the modesty panel using three #10 x 1" panhead
screws in each hinge. Attach the modesty panel to the bridge
using three of the provided #10 x 1" panhead screws in each
hinge. (Figure B).
3. Turn the bridge assembly upright. The bridge assembly can
be mounted between a single pedestal desk and credenza.
(Figure C).
Fig re A
Fig re B
Fig re C

Casegoods Assembly Instr ctions
President/ enator
Pri ted i U.S.A. © 2009 Kimball I ter atio al, I c. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741567 Revisio F-09
Page 2 of 2
Installation (contin ed)
4. Position the main units in the desired locations. Leave
enough space between the two units to allow for placement
of the bridge. Level main units. Install the flat brackets
to the undersides of the main units using the provided
#10 x 1" panhead screws. Locate the flat brackets using the
dimensions shown. Center the brackets with the edge of the
unit worksurfaces. (Figure D).
Note: Flat brackets are shipped on the underside of the
bridge top.
Use the pre-drilled holes in the desk end panel to mount
the quick align-n-lock fastener using the #8 x 5⁄8" panhead
screws. (Figure D). Fastener is shipped in the bridge
hardware bag.
5. Align the bridge worksurface to the main units. Position
the tops so the outer edges of the main units and bridge
worksurface are tight and flush against each other with no
gaps. Attach the bridge worksurface to the flat brackets
using the provided #10 x 1" panhead screws. (Figure E).
6. Level all units. Align all margins vertically between the
modesty panel and desk/credenza end panels. Eliminate all
gaps. Engage quick align-n-lock fasteners on lower portion
of modesty panel and rotate latch handles firmly. (Figure F).
Adjust levelers on modesty panel snug to floor.
Note: Do not over-tighten levelers, otherwise units will
become mis-aligned. (Figure G).
Fig re E
Fig re G
Fig re D
No gaps
No gaps
Do not over-tighten levelers
Flush with
no gaps Bridge
Align
Main unit
Fig re F
19"
4"
Mount Align-n-lock
fastener in pre-drilled
holes