Kimball Office Footprint User manual

Systems Assembly Instructions
Footprint®
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741501 Revision B-05
Page 1 of 2
Curved Profile Overhead
on Mobile Tables
Tools Required
■None
Package Contents
■1 Overhead ■2 FBOTS brackets
(packaged separately)
Installation
Note: Overheads are available for use with Crescent and
Hexagon Tables only. Overheads MUST be mounted on 59"
long Support Tubes. Remove Upper Screen if previously
installed.
1. Remove grommet caps using a large, flat blade screwdriver
or large coin. Turn counterclockwise; then press down on
one side to raise opposite edge and remove. (Figure A).
2. Insert the 59" long support tubes into openings until firmly
seated. Make sure that top collar is on top end of tube and
that exposed cap screw heads are facing toward the front
edge of table if a lower screen will be used. (Figure B).
Note: If a Lower Screen is to be used, refer to Table Screens
Assembly Instruction sheet and install now.
3. Turn support tubes so that cap screw heads are facing the
back edge of the table.
4. Position overhead mounting panel above support tubes
and lower evenly until slots engage on screw heads in tubes.
(Figure C). A magnified view of the slot/screw engagement
is shown in Figure D.
Note: If an Upper Screen is being used, refer to Table Screens
Assembly Instruction sheet.
Figure A
Figure B Figure C
Press down
Figure D
Screw head
orientation
Rotate
Screw head
orientation
Slots
Slot over
screw head

Systems Assembly Instructions
Footprint
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741501 Revision B-05
Page 2 of 2
Installation (continued)
5. Locate overhead brackets in the upper channel and position
as far apart as possible. (Figure E).
6. Open overhead door (if applicable) and “hook” cabinet
bracket into overhead bracket opening. (Figure F).
Note: When mounting overheads to Traxx®, please refer to
Assembly Instructions shipped with FBOTS brackets.
Note: When mounting overheads on Cetra® panels additional
overhead brackets (ASBL and ASBR) are required. Please refer
to Assembly Instructions shipped with brackets.
Figure E
Figure F
Overhead
Brackets
Printed in U.S.A. © 2005 Kimball International, Inc. T 800.482.1818 F 812.482.8300