Kimball Office Fluent User manual

Assembly Ins ruc ions
Fluent
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Part N . 2205354 Revisi n B-09
Page 1 of 2
Modesty Panels
Tools Required
Package Con en s
Ins alla ion
Resin Modesty panel:
1. Slide bracket onto resin modesty panel and tighten all set
screws. (Figure A).
2. Align modesty panel centered left to right (approximatley
11⁄2" on both sides), to dimension shown front to back with
worksurface, measure and mark hole locations. (Figure B).
3. Drill pilot holes to insure modesty is mounted perpendicular
to surface. Attach modesty panel assembly to worksurface as
shown. (Figure C).
Figure A
Figure B
Modesty Panel
orksurface
Tape Measure
Pencil
Screw Gun
#2 Phillips Head Bit
Bracket
Resin Modesty Fixed Modesty Technology Modesty
“L” Bracket
8-32 UNC
Set Screw
Hinge
#8 x 3⁄4"
Panhead Screw
#8 x 3⁄4"
Panhead Screw
#8 x 1"
Panhead Screw
9⁄64" Allen Tool
Figure C
51⁄2" max.
1" min.
9⁄64" Allen Tool
Pre-Drill Pilot Holes
Prior to Fastening Screws

Assembly Ins ruc ions
Fluent
Printed in U.S.A. © 2009 Kimball Internati nal, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibilit of the installing agent.
If ou have an questions concerning these instructions, please call Kimball Office Customer Service.
Part N . 2205354 Revisi n B-09
Page 2 of 2
Ins alla ion (con inued)
Fixed Modesty panel:
1. Attach “L” brackets to modesty using pre-drilled holes.
(Figure D).
2. Align modesty panel centered left to right, to dimension
shown front to back with worksurface, measure and mark
hole locations. (Figure E).
3. Drill pilot holes to insure modesty is mounted perpendicular
to surface. Attach modesty panel assembly to worksurface as
shown. (Figure F).
Technology Modesty Panel:
1. Align modesty panel centered left to right, to dimension
shown front to back with bridge, measure and mark hinge
location. (Figure G).
2. Drill pilot holes to insure modesty is mounted perpendicular
to surface. Attach modesty panel with hinges to worksurface
as shown. (Figure H).
Modesty Panel
orksurface
Figure F
Figure D
Figure E
Figure G
Figure H
Modesty Panel
orksurface
51⁄2" max.
1" min.
4"
Pre-Drill Pilot Holes
Prior to Fastening Screws
Pre-Drill Pilot Holes
Prior to Fastening Screws