Kimball Office KORE User manual

KORE™1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 2848178,-
Assembly Instructions
WORK DESK MODESTY
PANEL
Tools Required
 Cordless driver with magnetic post
 #2 Phillips Head Bit Drive
Hardware Required (Included)
L Bracket 2
#12 x 5/8” Wood Screws 8
Installation
1. Unpack modesty panel, L bracket, and hardware. See Fig-
ure A for package contents.
2. Place L bracket over pre-drilled holes and assemble with
#12 X 5/8” wood screws using #2 Phillips head drive. See
Figure B.
3. Place the worksurface up side down on a non-marring sur-
face.
4. Using a tape measure, position the modesty panel from the
approach side of the worksurface 3/8” in and predrill using
1/8” bit.
5. Assemble with #12 X 5/8” wood screws using #2 Phillips
bit drive. as shown in Figure C. Flip the worksurface back
over onto the bases.
Figure A
L BRACKET
Figure B
Figure C
1"
3/8”

KORE™2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 2848178,-
Assembly Instructions
Figure C
UTILITY CART MODESTY
PANEL
Tools Required
 Cordless driver with magnetic post
 M5 Hex Drive
 #2 Phillips Head Bit Drive
Hardware Required (Included)
L Bracket 2
#12 x 5/8” Wood Screws 8
M5 Button Head Cap Screw 4
Lower Mounting Bracket 1
Installation
1. Unpack modesty panel, Brackets, and hardware.
2. Place L bracket over pre-drilled holes and assemble with
#12 X 5/8” wood screws using #2 Phillips head drive. See
Figure A.
3. Assemble the Lower Mounting Bracket to the Lower Rail
on the Cart using included M5 Button Head Cap Screws as
seen in Figure B.
4. Slide the route on the bottom of the Modesty Panel slide
over the vertical tab of the lower mounting bracket and
pivot the modesty panel in place. Secure the Modesty pan-
el to the bottom of the bottom panel using #12 Wood
screws. See Figure C.
Figure A
Figure B