Kimball Office President User manual

Casegoods Assembly Instructions
President/Senator
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741516 Revision A-04
Page 1 of 2
Task/Reception Station
Tools Required
■Level ■#2 Phillips Head Bit
■Tape Measure ■³⁄₁₆" Drill Bit
■Cordless Drill
Package Contents
■2 Flat Brackets ■2 Flat Brackets
(attach worksurfaces) (attach modesty panels)
■32 #10 x 1" Panhead Screws ■32 #8 x ⁵⁄₈" Panhead Screws
(worksurfaces) (modesty panels)
■Foam tape (light blocker)
Installation
1. Task/Reception Stations are comprised of a Corner Unit,
one Left Return, and one Right Return. These units will not
stand alone, nor attach to other units in the series. Position
the units in their approximate desired location. (Figure A).
2. Unroll the foam tape and apply a single strip of tape, gray
side down, to the center of the exposed ends of the Corner
Unit. Remove the protective film from the exposed side of
each piece of tape. The foam tape is used as a light blocker
when panels are installed next to each other. (Figure A).
3. Level all units. Attach two flat brackets to the underside of
the worksurface on the Corner Unit on each side at the
locations shown in Figure B, using the provided #10 x 1"
Panhead Screws. Center the brackets with the edge of the
worksurface.
4. Position the Returns against the Corner Unit. Pull all Units
together so that the Corner and Return Unit worksurfaces
are flush and tight against each other with no gaps.
Note: The worksurfaces can be unscrewed from cleats
and adjusted to align, if necessary.
Align the Corner Unit Modesty Panels and the Return
Modesty Panels so they are flush and tight against each
other with no gaps. This can be done by adjusting the leg
levelers up/down on the Corner and Return Units.
(Figure B).
Figure A
Figure B
Apply Foam Tape
Flush with
no gaps
Peel off
Protective Film
Corner Unit
Right Return
Left Return
Center brackets on
edge of worksurface
Use Levelers
to adjust/align
4"
Flush with
no gaps
19"

Casegoods Assembly Instructions
President/Senator
Printed in U.S.A. © 2004 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741516 Revision A-04
Page 2 of 2
Installation (continued)
5. When all gaps are eliminated, attach the Corner Unit
Modesty Panels to the Return Unit Modesty Panels first
using two flat brackets on each side. Center the brackets
between each Modesty Panel and attach one flat bracket
towards the top of the Modesty Panels under the
worksurface and the other flat bracket towards the bottom
of the Modesty Panels using the provided #8 x ⁵⁄₈" Panhead
Screws. (Figure C). Fasten each Return worksurface to the
Corner Unit flat brackets using the provided #10 x 1"
Panhead Screws. (Figure C).
Note: The worksurface flat brackets are shipped on the
underside of the Return worksurface.
Figure C
Attach Returns
to Flat Brackets
Center Flat Bracket
between Modesty Panels.
Attach Flat Brackets to
Modesty Panels.