kingsley-bate Chelsea CO80 User manual

Kingsley-Bate
CO80 Chelsea Sofa
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CO-30/55/80
BACK SEAT INSERTS SEAT
*NOTE
A TENON
B MORTISE HOLE
END FRAME END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assem bly of the furniture pleas e match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully lay down the END FRAME with the stamped numbers or letters
on it and fit the SEAT & BACK tenons into the END FRAME m ortise
holes as shown in the assem bly photograph. If necessary, gently rock the
SEAT & BACK while pushing the tenons into place until the joints fit
snugly together (use a rubber m allet to drive the joints together if
necessary).
STEP-III
Fit the remaining END FRAME m ortise holes over and onto all exposed
tenons. Using a rubber m allet or re gular hammer with a wood block
between the ham mer and the wood, dr ive the tenons and m ortise holes
until all the joints fit snugly together.

STEP-IV
Hammer the dowels into their respective joints
(dowel bags are marked according to where
they go). Make sure not to hit other parts of
the bench. To avoid dim pling the wood, we
suggest you place a block of wood between
the dowel head and the hammer head for the last few blows. If dowels are not completely
flush, use a saw to cut the e nds and then sandpaper to sm ooth the top. * After ham mering, if
dowels still protrude DO NOT FORCE!
STEP-V
Place INSERTS into SEAT as shown In photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
1IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]