kingsley-bate Chelsea CO14 User manual

Kingsley-Bate
CO14 Chelsea Dining Side Chair
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CO-14
RIGHT END FRAME BACK SEAT LEFT END FRAME
* NOTE:
4A TENON
5B MORTISE HOLE
1STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid
marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding letters
or numbers stamped on the furniture.
2STEP-II
Fit the BACK and SEAT ten ons into the END FRAME
mortise holes using the stamped num bers or letters as
guides. If necessary, gently rock the BACK and SEAT
while pushing the tenons into the m ortise holes until all
joints fit snugly together.
3STEP-III
Fit the remaining END FRAME m ortise
holes over and onto all exposed tenons
and using a rubber mallet gently tap the
END FRAME evenly un til all joints fit
snugly together. Carefully hammer
dowels into the pre-drilled holes of the assembly, details are shown in the photographs. All
dowels and dowel holes are prope rly marked with stickers. NOTE: DO NOT FORCE THE
DOWELS; ANY EXCESS CAN EASILY BE SANDED AWAY. IF THE DOWELS ARE
NOT FLUSH DO NOT CONTINUE TO DRIVE THE DOWELS, YOU MIGHT
DAMAGE THE ITEM.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]