kingsley-bate SR-20 User manual

KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SR-20/4
LEGS TABLE TOP CROSS BARS
* NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid
marring the wood.
NOTE: During assembly of the furniture please match the tenons and mortise holes with the
corresponding letters or numbers stamped on the component parts.
STEP-II
Fit tenons of the CROSS BARS into the respective mortise holes of the LEGS as shown in
the above photographs. If necessary, gently rock the parts while pushing the tenons into the
mortise holes until joints fit snugly together. Secure the joints with the small dowels “S” as
shown in the photographs (to avoid marring the wood please use block of wood between
dowels and hammer for the last few blows).

STEP-III:
Fit this newly assembled table base
onto the TABLE TOP; matching the
letters stamped on the legs to the
letters shown on the TABLE TOP and
then secure with long dowels “L”
provided as shown in photographs.
NOTE: Upright by “lifting” table, rotating and setting down. Do not “roll” table over.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]