kingsley-bate Nantucket Settee NT55 User manual

Kingsley-Bate
NT55 Nantucket Settee
Assembly Instructions

KINGSLEY – BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE NT-55/80
RIGHT END FRAME LEFT END FRAME
BACK SEAT
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding letters or
numbers.
*NOTE:
A TENON
B MORTISE HOLE
STEP-II
Assemble the BACK and SEAT and secure with the knock down bolts provided. Please use a
proper, hand held screw driver. Using a power screw driver may damage the bolt.
STEP-III
Place the SEAT/BACK ass embly and BOTTOM
STRETCHER into the RI GHT END FRAME mortise
holes.

STEP-IV
Fit the LEFT END FRAME mortise holes over and onto t he BOTTOM
STRETCHER and SEAT/B ACK assembly tenons. If necessary, use a
rubber mallet to drive the joints snugly together.
STEP-VI
Insert all dowels as shown on asse mbly diagram before lowering sofa or settee to its upright
position.
DO NOT FORCE DOWELS FURTHER THAN THEY WILL GO. ANY EXCESS CAN
EASILY BE SANDED AWAY. TO PREVENT MARRING THE WOOD, PLEASE USE
THE WOOD BLOCK BETWEEN THE DO WEL AND THE HA MMER HEAD FOR
THE LAST FEW BLOWS.
**NOTE**
- We recommend that two people upright the settee or sofa.
- Lowering the sofa or settee before doweling the item may cause damage to the END
FRAMES.
IF YOU HAVE ANY QUESTION REGARDING ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]