Kohler Englefield Valencia Elite User manual

SHOWER
VALENCIA ELITE Alcove Pivot Door
-
Note: Tapware and accessories not included.
englefield.co.nz
1366031-A02-H October 2023

Before installing the shower please read these instructions carefully to familiarise
yourself with the required tools, materials and installation sequences. Please leave these
instructions for the consumer after installation. Refer to the separate care and maintenance
guide for important care and cleaning information.
Ensure that the shower tray and wall, if applicable, are completely finished prior to
installing your shower door and return. Follow all warnings, cautions and instructions
contained in this guide.
1. ENGLEFIELD strongly recommends that a minimum of TWO persons install this
enclosure due to the weight of the door panels.
2. Toughened safety glass cannot be cut. Risk of injury or product damage.
3. Wear protective footwear when lifting panels.
4. Wear safety glasses when drilling.
1. The wall retainers must be installed onto a waterproof, vertical and flat wall surface.
Failure to do so will result in an unsatisfactory seal, which may cause property damage.
The wall inclination (out of squareness) is recommended to be out by no more than
+/- 4mm/m.
2. Please install this door onto an ENGLEFIELD Quick - Fit shower tray only, unless
unless installing directly onto tiled walls and floor.
®
3. Care must be taken when drilling into walls and floors to avoid any hidden pipes or
wires.
4. It is the responsibility of the INSTALLER to ensure that the installation complies with
council and or local authority bylaws.
INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
BEFORE YOU BEGIN
SAFETY
!
!ATTENTION
Instructions, drawings, and diagrams contained in this manual present information available at the time of printing.
changes without further notice.
englefield.co.nz
1366031-A02-H October 2023 Page1

INSTALLATION INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED
PARTS IDENTIFICATION
3.0 mm
#1
Square
Drive
8 x Wall Plugs
1 x Hex Key
8 x Fixing Screws
1 x Pivot Door
Assembly
(fixed panel on
1200 doors only)
2 x Top Caps
2 x Top Caps
2 x Wall Channels
2 x Corner Covers
2 x Wall Finishing Strips
8 x Assembly Screws B
A
VALENCIA ELITE
3mm
Alcove Pivot Door
1 x Handle Assembly
1 x Hex Key


1 x Handle Kit
!
ATTENTION
Short section of drip
strip may be packed
with different seals.
Do not discard.
1 x Seal Pack
Door Fitting Kit
englefield.co.nz
1366031-A02-H October 2023 Page2

INSTALLATION INSTRUCTIONS
VALENCIA ELITE
CONSTRUCTION REQUIREMENTS
Due to the weight of the glass
panels Englefield strongly
recommends fixing the wall
retainers to double studs for
all installation types (as shown).
!ATTENTION
Wall Framing
Double
studs Double
studs
CD
Size
For acrylic tray with acrylic or tiled wall For tile floor and tile wall - Finished surfaces
Dim ‘A’
900 x 900 900
1000 x 1000 1000
Dim ‘B’
884
+2
-0
984
1200 x 900 900 1184
Size Dim ‘C’
900 N/A
1000 N/A
Dim ‘D’
856
+5
-0
956
1200 N/A 1156
NOTE: This setup allows for the use of standard
10mm wall board. A thicker wall board could make
the recess too narrow for the door system.
Finished /tiled hob to be:
1) Minimum 70mm wide.
2) 1-2ofall front to back is acceptable.
3) Level (+/-0mm) left or right.
70 min
± 0 mm
956 1156
1182
591
680
900
670
426
Valencia Elite ALC 10x10Valencia Elite ALC 9x9
Valencia Elite ALC 7.5x9
Valencia Elite ALC 12x9
680
982
491
441
1000
670
476
856
882
570
580
900 426
Valencia Elite ALC 9x7.5
AB
2025mm
Minimum
Height
1935mm
Min Height
Valencia Elite ALC 1000Valencia Elite ALC 900
738
510
Valencia Elite ALC 750 Valencia Elite ALC 1200
Alcove Pivot Door
750 N/A 738
378
759
570
880
440
457
900
500
383
765
750 x 900 900
759
900 x 750
767
882
englefield.co.nz
1366031-A02-H October 2023 Page3

INSTALLATION INSTRUCTIONS
VALENCIA ELITE Alcove Pivot Door
Tray: For tray installation refer to the instructions supplied with the tray.
Wall: For wall installation refer to the instructions supplied with the wall.
- Proceed to Door Installation.
- The door and return can be installed directly onto the wall and floor tiles.
- Proceed to Door installation.
OPTION 1 - Acrylic Wall & Tray
OPTION 2 - Tiled Wall & Acrylic Tray
OPTION 3 - Tiled Wall & Floor
INSTALLATION - Options
Tray: For tray installation please refer to the instructions supplied with the tray.
!ATTENTION
Tiled Wall:
Failure to install the complete door system before tiling may mean the door system
will not fit on the shower tray due to the tile thickness.
- Proceed to Door installation.
The complete door system MUST be installed onto the waterproof
membrane PRIOR TO WALL TILING.
englefield.co.nz
1366031-A02-H October 2023 Page4

1
± 0 mm
Caution: Ensure tray or tiled floor is
level & walls are vertical & square.
For tray base option:
For tiled floor option:
- Mark from back wall to outer edge
of both retainers with your preferred
dimension ‘A’.
Tip: Cover the waste to prevent the loss of
small parts. If installing onto a tray protect
the tray surface during installation.
INSTALLATION
INSTALLATION INSTRUCTIONS
VALENCIA ELITE
(a) Mark the locations of the wall retainers.
(b) This shower is reversible.
Please choose which side you would
like the door to open from.
Alcove Pivot Door
A
10 mm
10 mm
(15mm
on QFT)
(15mm on QFT)
- Mark 10mm in from top edge of tray.
- (Mark 15mm in on 90mm
sill height Quick-Fit Trays)
englefield.co.nz
1366031-A02-H October 2023 Page5

INSTALLATION INSTRUCTIONS
VALENCIA ELITE Alcove Pivot Door
2
(a)
Position a wall channel on the “handle side” wall. The flange with pre-drilled holes
should face inside the enclosure. Using a level, make sure that the channel is upright.
Mark the position of fixing holes down the centre of the channel, then remove channel.
Drill with a 3mm bit. For other types of wall structure, alternative fixings may be
required (not supplied).
(b)
(c)
Apply silicone sealant along the length of the wall and at the bottom where the wall
channel will be placed, including the top of the tray.
(d)
Position the wall channel on the wall and install the fixing screws .
(e)
Fully tighten the fixing screws, making sure that the wall channel remains vertical.
(f)
A
3 mm
x4
± 0 mm
x4
10 mm
A
x4
IMPORTANT! The handle side retainer must be fitted first.
englefield.co.nz
1366031-A02-H October 2023 Page6

INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
3
(e) Fit the free wall channel onto the hinge
side of door assembly and hold in place.
(a) Place the other wall channel on the opposing wall.
Use a level to ensure that it is upright.
Note! The hinge side wall channel is not fitted at this stage.
Mark fixing hole positions down the inner flange
of the channel, then remove the wall channel.
Drill with a 3mm bit. For other types of wall structure,
alternative fixings may be required (not supplied).
(b)
(c)
Apply silicone sealant along the length of the wall
and at the bottom where the wall channel will be
placed, including the top of the tray.
(d)
x4
englefield.co.nz
1366031-A02-H October 2023 Page7

(b) With the wall channel in position, insert the fixing screws into the pre-drilled holes.
(c) Use a level to ensure the channel is kept upright, then fully tighten the fixing screws.
(d) Remove any excess silicone sealant from inside the shower enclosure.
INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
A
x4
A
Inside of
enclosure
4
(a) Slot the door assembly into the pre-installed
(handle side) wall channel, and swing the
entire door frame into position.
Note! Be careful not to scratch the
extrusions or smudge the silicone
sealant during this process.
englefield.co.nz
1366031-A02-H October 2023 Page8

(a) Centralise the door frame within
the wall channels, making sure
that the door frame is square.
INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
5
± 0 mm
Ø 3 mm
x4
x4
B
(b) From the inside of the enclosure,
drill four holes in the door frame
through the centre marked points
on the wall channel with a 3mm
HSS drill (not supplied).
(c) Install and tighten the wall
channel assembly screws .
(d)
Repeat the process for the other
wall channel.
(e) Fit the corner covers to the wall
channels. They should ‘snap’ into
place.
B
englefield.co.nz
1366031-A02-H October 2023 Page9

INSTALLATION INSTRUCTIONSVALENCIA ELITE
6
Alcove Pivot Door
Door Seal
Door Seal
Vertical Door Seal
(b)
(a)
Install the door seals and magnetic strip onto the door.
Install the door handle, ensuring that the grub screws are on the underside.
a
750 DOORS
900 DOORS
1000 DOORS
[for 1200 doors
see page 11]
flap facing
into shower
englefield.co.nz
1366031-A02-H October 2023 Page10

INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
(c)
(b)
(a)
Install the vertical seal onto the fixed panel.
Install the door handle, ensuring that the grub screws are on the underside.
Door Seal
Door Seal
Magnetic Strip
1200 DOORS
[for 750,900,1000
doors see page 10]
6b
Install the door seals and magnetic strip onto the door panel.
Vertical Seal
fixed
panel
outside
inside
englefield.co.nz
1366031-A02-H October 2023 Page11

INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
7
wall board
retainer
channel
silicone
silicone or
adhesive
finishing
strip wall
liner
(a)
Apply sealant along the outside surfaces of the enclosure. Do not seal from inside.
Fit the caps to the top of the extrusions. Add silicone or modify caps to fit if required.
(b)
Install the wall finishing strips, if desired.
(c)
Allow the silicone sealant to cure for 24 hours before use.
Installation complete.
200mm up 200mm up
Entire
length
Entire
length
Entire
length
(d)
englefield.co.nz
1366031-A02-H October 2023 Page12

INSTALLATION INSTRUCTIONSVALENCIA ELITE Alcove Pivot Door
SPARE PARTS
Horizontal Seal
1365844 (750, 900, 1000)
1386135 (1200)
Rail Seal (1200 only)
1376825
Pivot Block (750, 900, 1000)
1365839-**
Pivot Block (1200)
1376827-**
Door Seal (750, 900, 1000)
1365843
Fixed Panel Seal (1200)
1376826
Wall Retainer
1278347-**
Retainer Cover Clip
1278349
Pivot Hinge
1365838-**
Retainer Cover
1278348-**
Wall Finishing Strip
1315530-**
Wall Plugs
Fixing Screws
Handle Assembly
1365840-**
Top Caps
Top Caps
Assembly Screws
Component Kit
1365841-**
Scan the QR barcode on the packaging
or underside of top caps to identify the
product SKU and date of manufacture.
** Colour code must be specified when ordering
Magnetic Strip Pair (750, 900, 1000)
1365842
Magnetic Strip Pair (1200)
1380255
Glass Aftercare Kit
98945A-NA
englefield.co.nz
1366031-A02-H October 2023 Page13
M5x4 Grub Screw
1459277-CP

INSTALLATION INSTRUCTIONS
CLEANING AND MAINTENANCE INSTRUCTIONS
Please refer to our website for cleaning instructions.
VALENCIA ELITE Alcove Pivot Door
englefield.co.nz
1366031-A02-H October 2023 Page14
CONTACT AND WARRANTY INFORMATION
NEW ZEALAND
Kohler New Zealand Limited
0800 100 382
AUSTRALIA
englefield.com
info@englefield.co.nz
englefield.co.nz