Kontron ePCI-201 User manual

P/N : M8004_INST Page 1 of 1 V 1.0 November 2004
READ ME FIRST
UNPACKING AND SAFETY PRECAUTIONS
Static Electricity
Since static electricity can cause damage to electronic devices, the following precautions should be
taken:
1. Keep the board in its anti-static package, until you are ready to install it.
2. Always touch a grounded surface or wear a grounding wrist strap before removing the board
from its package; this will discharge any static electricity that may have built up in your body.
3. Handle the board by the edges.
Storage Environment
Electronic boards are sensitive devices. Do not handle or store devices near strong electrostatic,
electromagnetic, magnetic or radioactive fields.
Power Supply
Before any installation or setup, ensure that the board is unplugged from power sources or
subsystems.
Unpacking
Follow these recommendations while unpacking:
1. After opening the box, save it as well as the packing material for possible future shipment.
2. Remove the board from its anti-static wrapping and place it on a grounded surface.
3. Inspect the board for damage. If there is any damage or missing items, notify Kontron
immediately.
When unpacking you will find:
1. One ePCI-201 SBC.
2. One CD-ROM containing drivers *
3. One heat sink.
4. One Quick Reference sheet.
5. Cables listed on the order.
6. One mezzanine with two USB connectors, one RCA connector and one video (DB15) connector.
Note:
For latest Technical Reference Manual, Quick Reference Sheet, drivers, BIOS and other
documentation, please consult our web site at: http://www.kontron.com or our FTP site at:
ftp://ftp.kontron.ca/Support
* Note that the Ethernet driver for the 82541ER available on the CD 4.1 is not working
properly. To download the new version, please visit www.kontron.com or
ftp.kontron.ca/support/

P/N : M8004_INST Page 2 of 2 V 1.0 November 2004
CPU and Heatsink Installation
Raise the Socket Actuation Lever up to 90º.
Locate the Pin 1 Notch.
Locate the Pin 1 Notch on the CPU.
Install the CPU onto Socket (match the pin 1 of CPU
with Pin 1 of Socket.
Lower the Socket Actuation Lever.
Remove the protective cover under the heatsink.
Install the CPU Heatsink onto the CPU and clip it to
the retention module.
Activate simultaneously the clips levers in order to
secure the heat sink.
Caution : You must apply pressure equally on both
side of the heatsink when you fasten the side
brackets.
Connect the CPU Fan cable to the CPU fan
connector (J21) located near the Memory Sockets.
IMPORTANT
1. Once the CPU is installed you must handle the board carefully and hold it on the
heatsink side.
2. The CPU Power cable must be installed on connector J22.
If not installed, the board will not start. This 4 wires cable comes from P4 ready power
supply or from the Backplane.
mPGA478B
mPGA478B
mPGA478B
mPGA478B
Pin 1
Notch
Pin 1 Notch
mPGA478B
mPGA478B