L.L.Bean MISSION MEDIA CENTER User manual

MISSION MEDIA CENTER
Thank you for purchasing our Mission Media Stand. Assembly of this product requires the use of a Phillips screwdriver
and hammer. We have found it helpful to have second person assist with assembly.
7400 0PKW9140106

STEP 1
Read through these instructions thoroughly
before beginning assembly. We have
found this to be of great value when first
assembling this product.
STEP 2
Remove all parts and hardware from
packing material. Wooden pieces should
be placed on a non-abrasive surface (like
the carton or carpet) to prevent damage to
the finish.
STEP 3
Identify all parts using diagram at right.
PARTS
(1) Top Assembly (A)
(2) Shelf Assembly (B)
(2) Side Assembly (C)
STEP 4
Identify and count hardware using
diagram at right.
STEP 5
Align Side Assembly (C) with
Middle Shelf and Bottom Shelf
(B) so that the countersunk holes
on the legs are facing outward.
Then line up with pilot holes in
skirts. The diagram to the right
shows the proper placement. A
second person's assistance would
be recommended to hold opposite
side of Shelving (B) being worked
on. Do not fully tighten screws
at this time.
STEP 6
Align 2nd Side Assembly
(C) with Middle Shelf and
Bottom Shelf (B) as shown
in STEP 5.

STEP 7
Place Top Surface (A) as shown to the
right so that holes in Sides (C) line up
with pilot holes in the skirts of Top
Assembly (A).
Fully tighten all the screws on both
sides at this time.
STEP 8
Finally, tap Wooden Plugs into holes
with hammer to conceal screws.

CARE
Dust as needed with a soft cloth. Clean
with damp cloth and mild solution of dish
soap. Polish with soft cloth and polish that
contains no pigments or silicone.
www.llbean.com
Product Support 1 800 341 4341