Liko 3136226 User manual

1 x
1. Slide the strap cover away from the strap
joint.
2. Loosen the strap and remove the safety
pin.
3. Adjust the strap to the desired length.
NOTE! Excessive strap must not be cut
o󰀨, due to the risk of the strap gliding
out.
Before the Extension belt is used for the rst time it has to be adjusted to an appropriate length. How to adjust
the strap is described below. See the instruction guide for MultirallTM overhead lift for more information on how to
use the Extension belt.
1.
3.
2.
1. Strap cover
2. Safety pin
3. Strap joint
Contains:
Extension Belt, adjustable
Assembly Instrucon
Prod. No 3136226, 3136227, 3136228, 3136229
7SE160242 Rev.3
ENGLISH 2021

6. Tighten the strap properly. Make sure
that the safety pin is correctly mounted,
so that it prevents the strap from gliding
out.
7. Slide the strap cover back over the
strap joint.
8. The extension belt is ready for use.
5. Replace the safety pin into the strap
fold.
4. Thread the folded strap end into the strap joint,
as indicated by the arrows. Make sure the strap
joint is facing the right way.
© Copyright Liko R&D AB 2021 ALL RIGHTS RESERVED.
Liko AB
Nedre vägen 100
SE-975 92 Luleå, Sweden
www.hillrom.com