Liko Uno 100 Series Manual

Uno 100 and 102 are electrically-powered mobile lifts,
designed to be used in most of the common lifting
situations, for example transfers between bed and
wheelchair, to and from the toilet and bathtub or for
lifting to and from the oor.
Selecting the appropriate slings and accessories for
each individual is important to assure maximum func-
tion and safety when using a patient lift.
Uno 100/102 - EM, EE, ES
Uno can be adjusted to three different heights to give
you the most appropriate lifting range. The mid-range
is the standard position, while the lower position may
be the most suitable for lifting children, or to/from the
oor. The upper position may be needed for higher
lifts, for example to beds and gurneys that cannot be
lowered.
IMPORTANT!
Carefully read instructions for the lift and lifting accessories before use. Lifting and transferring a person always
presents a potential risk. A thorough understanding of the contents of this instruction guide is essential. Only
trained personnel should use the equipment. If you have questions, please contact Liko or your local Liko
representative.
“Caution!” triangles are used to warn of situations that demand extra care and attention.
In this document, the person being lifted is referred to as the “patient” and the person helping them is referred to
as the “caregiver”.
English
Instruction Guide
7EN150104-01
2007-05-11
This Instruction Guide applies to:
Name Prod. No.
Uno 100 EE 2010011
Uno 100 EM 2010012
Uno 102 EM 2010003
Uno 102 EE 2010004
Uno 102 ES 2010005

2www.liko.com
Uno 100/102 • 7EN150104-01
Contents
Safety Instructions ................................................................... 3
Product Description .................................................................3
Technical Data ..........................................................................4
Measurements ..........................................................................4
Assembly Instructions .......................................................... 5-6
User´s Guide ............................................................................7
Charging the Batteries ..............................................................8
Maximum Load ........................................................................9
Recommended Lifting Accessories .................................... 9-10
Simple Troubleshooting ..........................................................11
Care and Maintenance ..........................................................12
NOTE!
This Instruction guide contains important information about the use of the product.
All personnel who use this product must be thoroughly familiar with the contents of this instruction guide.
Remember to keep the instructions where they are easily accessible for users of the product.

3www.liko.com
Uno 100/102 • 7EN150104-01
Product Description
Safety Instructions
Before using the lift, make certain that:
• the lift is assembled according to the instructions
• lifting accessories are correctly applied to the lift
• the batteries have been charged for at least 6 hours
• you have read and understood the instruction guides for the lift and lifting accessories
• personnel using the equipment have received appropriate instructions and training
• you have selected the correct type, size, material, and design of slings and accessories to safely meet the
patient’s needs.
Before lifting, always make certain that:
• the lifting accessories are not damaged
• the lifting accessory is correctly and securely applied to the patient, so that no personal injury can occur
• the lifting accessory is correctly applied to the lifting equipment
• the sling’s strap loops are correctly fastened to the slingbar hooks when the sling strap is extended, but before
the patient is lifted from the underlying surface.
Never leave a patient unattended in a lifting situation!
Uno 100/102 EM, EE, ES have been tested by an accredited testing institute and complies with the requirements
of directives for medical-technical Class 1 products (MDD 93/42/EEC).
Uno 100/102 EM, EE, ES complies with the requirements according to IEC 60601-1, IEC 60601-1-2, EN ISO
10535, UL 60601-1 and CAN/CSA C22.2 No. 601.1.
Particular care must be taken when using strong sources of potential disturbance, such as diathermy, etc, so that
cables are not positioned on or near the lift. If you have questions, please consult the responsible assistive-device
technician or the supplier.
Maximum Load Uno 100: 205 kg (450 lbs)
Maximum Load Uno 102: 175 kg (385 lbs)
1. Lift arm
2. Flexlink
3. Safety latches
4. Slingbar
5. Motor/actuator for lift mast
6. Front wheels
7. Base
8. Rear wheels with brakes
9. Locking handles
10. Motor for base-width adjustment (only mod. EE, ES)
11. Cable, handcontrol
12. Control box with emergency stop
13. Battery pack
14. Handcontrol
15. Product decal
16. Colour codes for sling sizes
17. Lift mast
18. Emergency lowering (mechanical)
7
4
3
5
6
1
14
15
17
2
8
10
11
9
13
12
16
18

4www.liko.com
Uno 100/102 • 7EN150104-01
Technical Data
Material: Painted steel with lacquer top coat.
Emergency
lowering: Mechanical (patented) and electrical.
Intermittent Int. Op 10/90, active operation max
operation: 2 min. Out of a time of 100, active
must be less than 10, though not
more than 2 min.
Degree of
protection: IP 43
Built for indoor operation.
Type B according to the degree of protection
against electric chock.
Class ll equipment.
Lifting speed: 3.0 cm/s without load
Model ES has two speeds: 3.0 and
2.0 cm/s (1.2 and 0.8 inch./s)
Batteries: 2 pcs. 12 V 2.9 Ah valve-regulated
lead-acid gel-type batteries. New
batteries available from supplier.
Battery charger: Built-in charger, 100-240 VAC, 50-60 Hz,
max. 400 mA.
Motor (mast): 24 V, 6 A, permanent magnetic motor
with mechanical safety mechanism
and safety nut.
Motor (Base): 24 V, 3.5 A, permanent magnetic motor.
Wheels: Standard front: 75 mm dual.
Standard rear: 75 mm single wheel
with brake.
Alt. front: 100 mm single.
Alt. rear: 100 mm single wheel with
brake.
A: Max. load and Weight in kg. Measures in cm.
B: Max. load and Weight in lbs. Measures in inches.
* These measures depend in which hole the mast is levelled an secured. See assembly instructions page 5. These measures
hold for the use of the standard slingbar. The change or complementary addition of other lifting accessories result in a change
of the lifting height.
** The rst measure holds for the use of standard wheels (75 mm wheel diameter). The second mesure holds for the use of
large wheels (100 mm wheel diameter).
Measurements
L
D
G
C
B
FF1
B1
A
E
Uno 100 Max. load L*
Max
L*
Min
A*
Max
A*
Min
B B1C D E* F** F1** G Weight
Tot
Weight
Part
Turning diameter
A205
171
166
161
61
56
51
190
185
180
144
139
134
106 86 69-110 53-97
110
105
100
11/16 5/9 70,5 38,1 19,9 118
B 450
67
65
63
24
22
20
79
77
75
57
55
53
42 34 27-43 21-38
44
42
39
4/6.3 2/3.5 27.8 84 43.9 46.5
Uno 102 Max. load L*
Max
L*
Min
A*
Max
A*
Min
B B1C D E* F** F1** G Weight
Tot
Weight
Part
Turning diameter
A175
179
174
169
52
47
42
200
195
190
142
137
132
123 104 69-116 56-109
110
105
100
11/16 5/9 81,5 40,3 20,3 118
B 385
71
69
67
21
19
17
79
77
75
56
54
52
49 41 27-46 22-43
44
42
39
4/6.3 2/3.5 32.1 88.3 44.7 51

5www.liko.com
Uno 100/102 • 7EN150104-01
Assembly Instructions
4. Connect cables as follows:
- Cable handcontrol to outlet 1.
- Cable motor for lift mast to outlet 2.
- Cable Motor for base-width adjustment to outlet 3
(only mod. EE, ES).
1. Remove the locking handles from the base and
place the lift mast in the socket on the base.
• Lift mast with lift arm, control box, motor/actuator
for lift mast, exlink, locking handles and slingbar
• Base (incl. motor for base-width adjustment for
mod. EE, ES)
• Lever for base width adjustment (mod. EM only)
Before assembly, make sure you have the following parts:
• Handcontrol with cable
• Battery pack and holder for cable
• Bag containing Instruction Guide, cable for char-
ging (with connection cable for charging) and the
decal "Using the lift".
3. Using the accompanying locking handles, secure
the lift mast in the desired position in the base.
Adjust the handles so that they point downward.
2. The lift height can be adjusted at three different
levels. Select one of the three holes, as shown in
the illustration above. The middle hole is recom-
mended in most cases. The bottom hole on the
mast is recommended when a greater lifting height
is desired. The upper hole is recommended when a
lower lifting height is desired.
The distance between two holes is 50 mm (2 inch.).
See Measurements, page 4.