luminii RSLW8 Channel User manual

Page 1 of 2
REV2.3
RSLW8 Channel - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
solder
pads
12
43
Always wear safety goggles when cutting.
If required for installation cut down RSLW8 aluminum extrusion
to desired length with hacksaw or miter saw that has an
appropriate blade for cutting aluminum.
RSLW8
profile
If required to fit the new RSLW8 length, cut LineLED strip/s in
between two rows of solder pads. Always cut LineLED from
end without connector/wire leads. Ensure that LineLED strip fits
completely inside the extrusion and the solder pads do not
touch metal end caps to avoid shorting of circuit.
Route channel into mounting material with proper
width and depth to accommodate RSLW8 aluminum
extrusion.
Refer to above dimensions when installing the RSLW8
aluminum extrusion.
5
wire leads
STEP A STEP B STEP C
drill location
for mounting
holes
ensure flathead screws are
tightened flush with or below
extrusion surface before
installing LineLED strip/s
countersink
hole for
flathead
screws
Mounting for RSLW8 extrusion can
be achieved by screw fasteners or
construction adhesive. See both
mounting methods shown left and
right.
OR
mounting
surface flathead screws
aluminum
extrusion
apply construction adhesive to
bottom of mounting channel
RSLW8 aluminum
extrusion
aluminum
extrusion
mounting
surface
aluminum
extrusion
1.16”
0.22”
0.89”
Line LED strip

Page 2 of 2
REV2.3
RSLW8 Channel - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
7
Ensure power is off to power supply!
Also ensure the correct (wattage and voltage) power
supply is used to power LineLED. Then proceed to
connect LineLED wires from RSLW8 extrusion to power
supply. For more information please refer to power
supply and LineLED wiring instructions.
power to LineLED of
RSLW8 extrusion
class II
power
supply
line voltage wires
6Wipe extrusion with a wet rag
and ensure it is completely dry
before installing LineLED. Gently
press LineLED strip/s onto aluminum
extrusion and then proceed to install
endcaps.
Note - Maximum run per power
feed is determined by the type of
linear LED products selected. Please
consult the specifications of the
linear LEDs used.
low voltage wires
feed LineLED
wires through
opening in
endcap
remove paperbacking from adhesive tape of the
LineLED before installing onto the extrusion
longer runs of RSLW8
can be created by
locating multiple
aluminum extrusions
end to end
endcap
endcap
Size polycarbonate diffuser lens by cutting to appropriate
length to fit aluminum extrusion. Install lens by snapping into
aluminum extrusion.
diffuser
lens
wires to
power
supply
8