
DONNING THE COMFORT ARM LINER™
Slide the Comfort Arm Liner™ all the way up to the axilla. The thumb should
extend through the hole, and the end of the sleeve should be at the base of
the ngers.
DONNING THE MEASURE-UP™ ARMSLEEVE
STEP 1: Slide the armsleeve all the way up to the axilla. The thumb should
extend through the side of the foam liner, and the end of the sleeve should be
at the base of the ngers. Ensure that:
• The foam padding sandwiches the hand.
• The thumb has mobility.
• The gradient measuring strip is positioned on the inside of the arm.
• The D-rings are located on the inside of the arm, with the straps
pointing away from the body.
FASTENING THE MEASURE-UP™ ARMSLEEVE
STEP 2: Smooth the arm liner beneath the armsleeve so that there are no wrinkles.
STEP 3: Apply the Measure-Up™ Hand Cover, see “Donning the Measure-Up Hand Cover” above.
STEP 4: Lift up the strap nearest to the wrist, pull the strap up and away from the arm, and
then around the top of the arm and fasten to the sleeve.
DONNING THE MEASURE-UP™ HAND COVER
STEP 1: Right and Left Hand Covers are different; make sure to verify the correct one is being used.
STEP 2: To apply the hand wrap, tighten the first armsleeve strap as per the sleeve instructions. Be
sure not to tighten the strap too tight at this point. Make sure your hand is positioned with the thumb
pointing upwards between the edges of the inner lining. The base of the armsleeve should be at the
wrist.
STEP 3: Position the hand cover on the outside of the sleeve on the lateral part of the arm, so that
the straps extend from the back of the hand past the thumb to the palm, pointing in the
opposite direction as the arm straps.
STEP 4: Once the proper position of the hand cover has been determined, reattach it in the same
position under the first strap on the armsleeve so it can be left in place for subsequent
applications.
STEP 5: Unroll the hand strap closest to the armsleeve, and wrap the strap around the hand
between the thumb and the wrist. Attach to the back of the hand.
STEP 6: If necessary, realign the inner lining so that it extends along the base of the fingers, then wrap
the other hand strap around the palm of the hand. The edge should be at the base of the fingers.
Fasten to the back of the hand.
STEP 7: Readjust the two bands as needed, so that they provide firm and comfortable compression.
If the opening for the thumb does not align with the thumb, reposition the hand cover on the
armsleeve (step 3 above).
STEP 8: If the wrap still binds around the
base of the thumb, the circular opening
for the thumb can be cut larger. To avoid
cutting too much, cut no more than 0.3cm
at a time. Foam padding can also be used
to protect this area if needed: place the
padding around the base of the thumb
under the hand cover.
REMOVAL
To remove the wrap unfasten the two bands and roll them back onto themselves.
ARMSLEEVE DIRECTIONS FOR USE
HAND COVER DIRECTIONS FOR USE
STEP 1
STEP 4
STEP 3
STEP 5
STEP 5
STEP 6
STEP 8
DONNING COMFORT ARM LINER™
STEP 4