MRC LOM-150DIG User manual

PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone] [email protected]
MRC.VER.01-8.11
Operation Manual for
LOM-150DIG/500DIG
LOW-TEMP. SHAKER INCUBATOR

General Comments:
Do not block the cooling vents (fig. 1).
Allow 30cm clearance on all sides of the appliance for proper ventilation.
Do not change internal parameters in the controller other than the set point.
At a temperature of 30 ° C, the cooling should be turned on.
At temperatures above 30 ° C, turn off the cooling system.
Clean the compartment with a wet cloth that does not scratch or with special
stainless-steel cleaning spray.
Do not pour liquids into the chamber
If liquids are spilled into the chambers, they should be dried as soon as
possible.
Once a month, open the front panel (mesh) and clean the dust from the
cooling radiator (fig. 1) with air pressure or with a soft brush.
Lack of preventive maintenance and dust removal once a month from the
cooling radiator, will necessarily damage the cooling system
רויא1
Figure 1