Nav TV GVIF-CTS User manual

Jack Randall v1.2
July 13, 2012
1 | P a g e
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for rear camera use and the video input is for off-road use and passenger entertainment only.
100 NW 11th Street, Boca Raton, FL 33432 TEL [phone] FAX [phone]
www.nav-tv.com i[email protected]
GVIF-CTS
Allows the addition of a rear camera and external video sources to a Cadillac CTS with a motorized screen.
What’s in the box
1. Mode Switch
2. Remote Control
3. Power/CAN Harness
4. IR Receiver
5. AV Harness
6. GVIF Module
7. GVIF Cables
Operation
When used for a backup camera only, the module
operates automatically when the vehicle is shifted
into Reverse, and no user interaction is required.
When used for Audio*/Video input, the supplied
Mode button is used to switch between sources.
* Note that this module is video only and does not provide an
audio input. When adding one or more A/V sources, the
audio input will be through the vehicle’s Aux jack. (If installing
multiple A/V sources, use the A/V Out RCA’s of the module, if
only a single audio source is being added, connect the audio
source directly to the jack.)

Jack Randall v1.2
July 13, 2012
2 | P a g e
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for rear camera use and the video input is for off-road use and passenger entertainment only.
Installation
1. Using a plastic pry tool, remove the trim
panel that goes across the dash.
2. With the plastic pry tool, pry up the (2)
trim panels around the gear selector
panel.
3. Place the vehicle into “Drive”, DO NOT
START VEHICLE. Pull up the gear selector
panel and pull up around the shifter.
4. Remove the (2) 7mm screws from around
the radio/HVAC panel, then gently pry
around the panel to remove.
5. Disconnect the trim panel wiring and
cigarette lighter plug.
6. Remove the (4) 7mm screws from around
the radio and remove the radio.
7. Locate the factory GVIF cable (square,
Light Blue connector, which looks like it
has a USB plug inside) and remove it.
8. Note the GVIF cables from the Nav-TV
module have one that goes to the radio
and another that goes to the cable.
9. Connect the wiring from the GVIF module
to the factory cable and radio.
10. Connect the following wires on the
Power/CAN harness:
a. Red wire (12v Accessory): pin 21
(Brown) of Light Green connector of
the BCM.
b. Black wire (Ground): connect to
chassis ground.
c. Gray wire (Camera/Reverse trigger):
pin 2 (Light Green) of the Pink
connector of the BCM.(Optional: only
when installing camera.)
(BCM is located above the gas pedal.)
11. Make all necessary A/V connections.
12. If only adding a camera, set Dipswitches 1
and 7 Down, and the rest Up.
13. Test system.
The audio is connected either behind radio or at
the AUX jack.
All other wires on module are not used.
Remove
7mm