Nav TV W212 VIM User manual

Agreement :
End user agrees to use this product in compliance with all State and Federal laws. NAV
misuse of its product. If you do not agree, please d
intended for off-
road use and passenger entertain
100 NW 11
th
Street, Boca Raton, FL 33432
Enables video in motion for factory DVD playback
What’s in the box
•
Video in Motion (V M) filter
•T-Harness
•USB cable
nstallation
1.
Open the glove compartment to gain
access to (2) metal ret
ention clips
l
ocated just behind the wood trim.
Using a right angle pick tool,
down the retention clips to release the
locks on the back side of the wood grain
trim.
2.
Using a plastic pry tool, gently put
pressure on the back side of the trim.
DO NOT PRY OFF! With pressure
applied, look inside the 2 center AC
vents. On e
ither side will be a plastic
retent
ion clip. Using a right angle pick
tool, carefully reach into the vents to
pull back each
clip on either side to
release the wood trim. Once released,
remove from vehicle.
3. The radio is held in by (
2) T20 T
End user agrees to use this product in compliance with all State and Federal laws. NAV
-
V Corp. would not be held liable for
e, please discontinue use immediately and r
eturn product to place of purchas
entertainment only.
Street, Boca Raton, FL 33432
TEL [phone] FAX [phone]
www.nav-tv.com inf[email protected]
W212 VIM
Enables video in motion for factory DVD playback
on 2010 and up E
Video in Motion (V M) filter
Open the glove compartment to gain
ention clips
ocated just behind the wood trim.
Using a right angle pick tool,
gently pull
down the retention clips to release the
locks on the back side of the wood grain
Using a plastic pry tool, gently put
pressure on the back side of the trim.
DO NOT PRY OFF! With pressure
applied, look inside the 2 center AC
ither side will be a plastic
ion clip. Using a right angle pick
tool, carefully reach into the vents to
clip on either side to
release the wood trim. Once released,
2) T20 T
orx bolts
Jack Randall
March 25, 2010
1 | P a g e
V Corp. would not be held liable for
of purchase. his product is
on 2010 and up E
-Class

Agreement :
End user agrees to use this product in compliance with all State and Federal laws. NAV
misuse of its product. If you do not agree, please d
intended for off-
road use and passenger entertain
Operation
To operate the video in motion, press the return
button on
the steering wheel 2 times. To disable
video in motion, repeat this step.
*NOTE –
VIM will be reset with every key cycle.
that
are located on the top of the radio.
Using an angled skew driver, loosen the
screws all the way to release the radio.
*NOTE –
The screws will not pull out,
they move b r down
on the b ckside
of the r dio to rele se the r dio from
the d sh.
4. Remove the ra
dio from the dash.
5.
nstall provided harness and filter. Be
sure to plug in USB cable and run it to
an accessible location for future
updates.
6. Reinstall in reverse order.
End user agrees to use this product in compliance with all State and Federal laws. NAV
-
V Corp. would not be held liable for
e, please discontinue use immediately and r
eturn product to place of purchas
entertainment only.
To operate the video in motion, press the return
the steering wheel 2 times. To disable
VIM will be reset with every key cycle.
are located on the top of the radio.
Using an angled skew driver, loosen the
screws all the way to release the radio.
The screws will not pull out,
on the b ckside
of the r dio to rele se the r dio from
dio from the dash.
nstall provided harness and filter. Be
sure to plug in USB cable and run it to
an accessible location for future
Jack Randall
March 25, 2010
2 | P a g e
V Corp. would not be held liable for
of purchase. his product is