Ojmar INFOTERMINAL User manual

INFOTERMINAL
ASSEMBLY INSTRUCTIONS
V.01

1. INFOTERMINAL INSTALLATION
2. INFOTERMINAL CONNECTION
3. INFOTERMINAL PLACEMENT
4. ADJUSTMENT OF INFOTERMINAL
To install the Infoterminal, 4 holes must be made in the wall to fasten the
support and a hole to pass through and house the alignment and network
cable. Install the bracket after drilling the holes in the wall. (See gure 2)
After putting up the bracket, pass the RJ-45 power and Ethernet cable
through the central hole and connect it to the Infoterminal at the back.
After connecting the power and network cables to the Infoterminal, put it onto
the bracket. To do this, slide it from top to bottom, inserting the 4 bracket
plates into the Infoterminal’s slots and putting the cables inside the wall cavity.
Finally, adjust the Infoterminal by tightening the two screws on its bottom.
1. ASSEMBLY INSTRUCTIONS

2. TECHNICAL DRAWINGS
225,15
40
282
6
315,4
258,15
R 10
132,8
216
152,5
129
5
79,5
313,5
258,15
Figure 2
Figure 1

INTELLIGENT LOCKING SYSTEMS
®
CONTACT
[e-mail]
+34.943.748.484
OJMAR HQ
Polígono Industrial de Lerun
20870 Elgoibar - SPAIN
OJMAR USA
17155 Von Karman Ave, S111
Irvine CA. 92614 - USA
www.ojmar.com