www.philips.com/welcome
Register your product and get support at
ENG Quick Start Guide
2
4
English
Install the car audio 1
1If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
2Take out the original car audio and keep
the screws.
3Mount the supplied mounting brackets
onto the unit with the supplied screws. a
4Connect wires 2.
5Take off the two screws on the top side of
the unit. b
6Slide the unit into the dashboard until a
click sound is heard. c
7Fix the unit onto the dashboard with
screws. d
8Reconnect the negative terminal of the car
battery.
Turn on
Caution
Risk of road accidents! Never watch video or
adjust settings while you drive.
1Press to turn on the unit.
The available OSD (On-Screen Display)»
languages are displayed.
2Tap a language.
The OSD language is changed to the»
selected language immediately.
CID3292
Set date and time
1Press MENU.
The main menu is displayed.»
2Tap [Settings].
3Tap [Time].
The date/time setup menu is displayed.»
Set date
1Tap [Date].
2Tap the displayed date information.
A submenu is displayed.»
3Tap or to set year, month and day.
Set time mode
1Tap [Time mode].
2Tap [12H] or [24H] to select time mode.
Set time
1Tap [Time].
2Tap the displayed time.
A submenu is displayed.»
3Tap or to set hour and minute.
Adjust screen
To turn off the screen
1Press DISP for over 2 seconds
To adjust screen brightness
1Press DISP.
2Rotate VOL to adjust brightness.
Use map
Note
You may need to upgrade the map (sold
separately) before using it (see “Upgrade the
map” section)
1Tap the upper left corner to display home
menu.
2Tap [Navigation].
The navigation menu is displayed in a»
few seconds.
3Refer to the map manual to operate the
navigation tool.
Listen to Radio
1Tap to display home menu.
2Tap [Radio].
Band and frequency information is»
displayed.
3Tap on FM or AM to select band:
4 %ULHÁ\WDS or to tune to a radio station
by step.
Play disc 3
You can play video, audio or images stored on the
following discs:
DVD video, DVD-R, DVD-RW
VCD
Audio CD, CD-R, CD-RW
1Inser t the disc into the disc slot with label
side facing up.
Play starts automatically.»
To remove the disc, press the»button.
Connect USB device 4
1Open the USB door.
2Inser t the USB device to the USB socket.
Play starts automatically.»
Note
To remove the USB device, switch to disc,
UDGLRRURWKHUVRXUFHÀUVW
Play with Bluetooth device
Pair the Bluetooth-enabled devices
To connect your Bluetooth device to the unit, you
need to pair the device to the unit. Pairing needs
only to be done once.
You can pair up to eight devices.
1Search for Bluetooth device with the device.
2Select “CID3292” in the pairing list.
3Enter default password “0000”.
if pairing succeeds. phone call record is»
displayed.
Make a call
1Pair the phone with the unit.
2Tap to display the home menu.
3Tap [Bluetooth].
The Bluetooth menu is displayed.»
4Tap or to select the paired phone, then
tap .
5Tap or to search for phone number
from the following list:
Or tap to dial number directly, then tap
to dial.
Receive call
By default, all incoming calls are received
automatically.
1If there is incoming call, [Incoming call...]
ÁDVKHVRQWKHVFUHHQ6SHDNLQWRWKH
Bluetooth microphone.
2When conversation ends, tap (red) to
terminate the call.
3
1a
b
c
d
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
CID3292_00_QSG_V2.0
Yellow
Yellow
Rear display
Rear display
Radio antenna
GPS antenna
Optional accessory
White
White
Red
Red
Brown
Amplifier
AV system
AV system
AUXAUX
Red
White
Yellow
Red
White
Yellow
Remark:
Connect the AV IN wire which is marked as cto the AV IN socket on front panel.
Gearbox
Blue/white
Pink
Green/white
Yellow Green Blue
Yellow
Connect to the positive (+) terminal of
reverse driving light
c
CID3292_00_QSG_V2.0.indd 1 6/4/2010 4:18:58 PM
