Rapid Racking Heavy duty work station User manual

Heavy duty work station
Assembly instruction
AIW012

HEAVY DUTY WORK STATION
IMPORTANT - ASSEMBLY INSTRUCTIONS
AIW012
1Fit plastic feet L, to the bottom of uprights
A, Band C, ensuring the keyhole slots are the
correct way up as illustrated.
2For a 2 shelf unit fit side beams, D, into
uprights, Aand B. The lower beams D, may be
fitted at a shelf height not exceeding 300 mm
from the floor. The top beam Dmust be fitted in
the top 2 keyhole slots of uprights B.
3For T-Bar unit substitute the lower side beams D,
for T-Bar side beams H.
4Fit 4 x front and rear beams E, into uprights A
and Bat the same levels as side beams D.
For T-Bar unit leave off lower beams E, and
substitute for T-Bar M.
5Fit shelf supports F, and work surfaces J.
6Fit rear beams E, into uprights A, at the desired
levels for the upper shelf.
7Take uprights C, and fit upper side beams Gin
place, level with the 2 upper front and rear
beams E.
8Fit the remaining 2 upper front beams E, into
uprights C, at the same level as the upper side
beams G.
9Fit the upper shelves I, and plastic caps on the
top of uprights A, Band C.
ASSEMBLY
We advise the use of
protective gloves and
goggles, or eyeglasses
when assembling this
product.
Tools required:
Rubber mallet
Illustration shows the
2 shelf Work Station
A
Illustration shows the T-Bar
Work Station with 1
–
2shelf
M
B
C
D
D
E
G
F
I
J
E
L
K
H

COMPONENTS
HEAVY DUTY WORK STATION
IMPORTANT- ASSEMBLY INSTRUCTIONS
AIW012
A
Keep heavier items
on the bottom shelves
Do not climb
on your shelving
Make sure it is on a
level and even floor
Keep your
shelving dry
SAFETY
DSide beam
4 of per workstation
2 of per T-Bar
760 mm or 915mm
LPlastic feet
6 of
KPlastic caps
6 of
B C
Uprights
1 of each pair
EFront and rear beams
6 of - T-Bar Work Surface
7 of - 1
–
2shelf Work Station
8 of - Work Station
1830mm or 2440 mm
FShelf support beam
2 of - Work Station
760 mm or 915 mm
GUpper side beam
4 of
305 mm or 380 mm
IHigh density chipboard or melamine shelves
2 of - for top shelves
Sizes to suit
2 of - Work Station
1 of - T-Bar
Sizes to suit
MT-Bar
1 of
1830mm and 2440 mm
1675mm
J
915 mm
750 mm
HT-bar side beams
2 of
760mm or 915mm
Please note
additional lugs
Chipboard or melamine
shelf work surface
N1
–
2shelf
1 of per 1
–
2shelf unit