Rapid Racking Modular workstation User manual

Modular workstation
Assembly instruction
AIW001

COMPONENTS
A
B
1524mm Uprights
2 of
CFront & rear beams
total 4 of
DUpper side beams
2 of
ELower side beams
2 of
PDrawer side beams
2 of T2 door cupboard
VPegwall panel
WSolid drawer
FUpper shelf support
(front to back) 1 of
JRebated MDF
work surface
KMDF bottom
half shelf
LMDF upper
shelf
MPlastic feet NPlastic caps
GLower shelf support
(left to right)
1 of
HUpper cantilever
shelf support
IBack panel
915mm Uprights
2 of
QMDF drawer
base
RDrawer runners
SM4 Nuts and
bolts
UM5 Screws
MODULAR WORKSTATIONS
IMPORTANT - ASSEMBLY INSTRUCTIONS

1Assemble side steel first - A,B,D,E, and P,
if a drawer is fitted (Fit feet).
2Add front and rear beam C (4 off).
3Add shelf support Fand G.
4Insert back panel Iand capture behind the
upper raised beam.
5Add work surface J, under bottom lip of back
panel I.
6Add upper cantilever shelf Hand remaining
MDF shelves Land K.
7If drawers are fitted, attach runner R, to
drawer Wwith 4 screws S(see illustration).
8Fit drawer to unit using 4 screws S(see
illustration).
9Fit drawer base Q.
10 For the ‘Compact Station’ version with
cupboard - there is no upper rear beam Cor
cantilever shelf assembly Hand L.
After instruction 3 attach the cupboard Tto
the rear uprights Ausing screws U. Continue
then with instruction 5
A
B
C
C
C
C
D
E
F
G
H
I
J
K
L
M
N
P
Q
R
W
Tools required: Rubber mallet,
small blade screw driver, small
pair of pliers or 7mm spanner.
We advise the use of protective
gloves and goggles, or eyeglasses
when assembling this product.
Fitting Drawer 1First fit runners to
support beams P,
using screws S
2Fit runners to drawer
sides using screws S Front
MODULAR WORKSTATIONS
IMPORTANT - ASSEMBLY INSTRUCTIONS