Rapid Racking Heavy duty workbench User manual

Heavy duty workbench
Assembly instruction
AIW013

HEAVY DUTY WORK BENCH
IMPORTANT - ASSEMBLY INSTRUCTIONS
AIW013
1Fit plastic feet, F, to the bottom of uprights A.
2For 2 shelf unit, fit side beams Bto uprights
Aas illustrated, the lower beams B, may be
fitted at the shelf height of your choice up to
300 mm from the floor.
3For T-Bar and 11
–
2shelf unit substitute the
lower side beams B, for T-Bar side beams I.
4Fit front and rear beams C. Four of for the 2
shelf unit, three of for the 11
–
2shelf unit and
two off for the T-Bar unit. For the 11
–
2shelf
and T-bar fit the T-bar beam H.
5Fit the shelf supports D, and place the work
surfaces, Eand J, in place. Fit the bottom
shelf J locating with retainers K.
6Fit 4 plastic caps G, on top of uprights A.
ASSEMBLY
We advise the use of protective
gloves and goggles, or eyeglasses
when assembling this product.
Tools required: Rubber mallet
A
Illustration shows the
2 shelf Work Bench
A
B
B
C
E
D
F
G
Illustration shows the
T-Bar 11
–
2shelf Work Bench.
For 2 half shelf bench repeat
components H, I, J and K.
H
I
J
(See note)
overleaf
K

Uprights
4 of
COMPONENTS
HEAVY DUTY WORK BENCH
IMPORTANT- ASSEMBLY INSTRUCTIONS
AIW013
A
CFront and rear beams
4 of per 2 shelf and 2 half shelf configuration
3 of per 11
–
2shelf configuration
2 of per T-Bar configuration
915mm H
Keep heavier items
on the bottom shelves
Do not climb
on your shelving
Make sure it is on a
level and even floor
Keep your
shelving dry
SAFETY
BSide beams
4 of per workbench
2 of per T-Bar bench
2 of per half shelf bench
760mm or 915 mm
DMiddle support beam
1 of per shelf level
760mm or 915mm
FPlastic feet
4 of
GPlastic caps
4 of
EHigh density chipboard or melamine shelves
1 of per shelf level
Depths and widths to suit
HT-Bar beam
1 of per T-Bar 11
–
2
shelf conguration
2 of per 2 half shelf conguration
1220mm, 1524mm,
1830mm or 2440mm
915 mm, 1220mm, 1524mm,
1830 mm or 2440mm
IT-Bar Sidebeams
2 of per T-Bar 1
1
–
2shelf configuration
4 of per 2 half shelf configuration
J
1
–
2High density
chipboard or melamine shelves
1 of per shelf level
Depths and widths to suit
(Not required on
915 mm W unit)
KLower shelf retainer
2 of per
lower shelf
Please note
additional lugs