San Jamar C3400C User manual

Rotate adjustment ring in
smaller increments until
one-at-a-time dispensing is
achieved.
STAINLESS STEEL CUP DISPENSER
Thank you for choosing the Stainless Steel Cup Dispenser from San Jamar.We appreciate your business and are
condent that this NSF certied cup dispenser will improve the image and efciency of your operation. Enjoy!
Remove dispenser from
mounting ange by rotating
dispenser counter-clockwise.
Remove dispenser from mounting ange by rotating dispenser
counter-clockwise.
Rotate adjustment ring until
cups are secure.
Release locking tabs of trim ring
by applying pressure to tabs
from inside the cup dispenser
with a athead screwdriver to
disengage
Once all three tabs are
disengaged, lift upward on the
trim ring to remove.
Disassembly continued on
reverse side.
Loosen the thumbnut using
either a athead screwdriver
or a dime.
Insert desired cups that fall
within adjustment range.
Remove the pusher: the
pusher will slide out by tilting
the dispenser.
Remove the end cap and spring of the dispenser by depressing the
exposed tabs and rotating the cap to pull outward – the spring will
come along with the end cap.
Tighten thumbnut to maintain
dispensing adjustment using
either a athead screwdriver
or a dime.
ADJUSTING THE DISPENSER
1.
1a. 2a. 2b.1b.
5. 6.
4.
4. 5.
2. 3.
3.
DISASSEMBLY

San Jamar
555 Koopman Lane
Elkhorn, Wisconsin 53121
USA
T: +1.262.723.6133
F: +1.262.226.8664
[email protected]
www.sanjamar.com
Europe
Schoorstraat 26a, bus 1
2220 Heist-op-den-Berg
BELGIUM
T: [phone]
F: [phone]
[e-mail]
México
Av. Paseo de la Reforma No. 350 - 10
Col. Juarez
Deleg. Cuauhtemoc, CP 06600
MEXICO, D.F.
T: [phone]
[e-mail]
© Copyright San Jamar, Inc. 2018
Canada
3280 Bloor Street West
Suite 1140
11th Floor, Centre Tower
Toronto, ON M8X 2X3
CANADA
T: +1.262.723.6133
F: +1.262.226.8664
[e-mail] 103391_RevA©Copyright San Jamar 2018
Remove all three adjustment clips by lifting and pulling the clip from
the dispenser tube.
Remove the thumbnut that is
located on the underside of
the adjustment ring using a
athead screwdriver or a dime.
Remove adjustment ring
by lifting up and over the
dispenser tube.
6a.
1a.
7a.
2a.
7a.
6b.
1b.
7b.
2b.
7b.
DISASSEMBLY CONTINUED
REASSEMBLY
Attach adjustment ring by dropping trim
ring around the dispenser tube; ensure
that the post for the thumbnut is aligned
with opening on adjustment ring.
Apply downward pressure to
attach trim ring. When properly
aligned, the trim ring will snap
into place inside the dispenser.
Tighten thumbnut with a
athead screwdriver or a dime
to secure the adjustment ring.
Insert the pusher. Insert both the spring and
end cap.
Align trim ring & locking tabs
with the slots on the dispenser
tube.
Insert adjustment clips by threading them into the
slots on the body of the tube. When fully inserted they
should appear as pictured.
Insert assembled dispenser back into installed mounting ange and
rotate clockwise to secure unit.
4. 5. 6.3.