MOUNTING INSTRUCTIONS (Dispenser must be mounted level)
The user is responsible for the proper installation and use of this dispenser.
Equipment needed:
Measuring tape
Level
Screwdriver
Eye protection
Pencil
Drill and drill bit
Assemble appropriate fasteners (screws, bolts, anchors, washers, etc.) for mounting.
1. Determine position on wall/surface with unit open. Through the holes at the back of the unit, use pencil to mark the spots where
the drilling will be necessary. Be sure unit is level before marking holes. WARNING: Proper function of this dispenser
requires level mounting. Try to mark spots as close as possible to the outer edges.
2. Drill the marked spots on the wall/surface with appropriate sized drill bit suitable for the wall material and fasteners used.
3. Complete the installation. Be sure to use fasteners (and anchors) in all mounting holes that are appropriate for the wall/surface to
which the dispenser will be mounted. The installation should be done with a flat washer between the head of the fastener and the
inside back of the dispenser.
The Tear-N-Dry Essence is powered by 4 D-cell alkaline batteries. Take care to load batteries in correct orientation as shown on the
battery compartment inside door. After inserting batteries wait 5 seconds before closing cover. If the batteries are loaded incorrectly,
the Tear-N-Dry Essence will not function. A flashing red indicator light indicates that batteries need to be replaced. !WARNING:
Do not use rechargeable or NiCad batteries as these may cause damage to your dispenser or personal injury.
Tear-N-Dry Essence
TOUCHLESS TOWEL DISPENSERS INSTRUCTIONS
Take care to load batteries in correct orientation, with positive end of battery towards the left as you are facing the dispenser.
(Tenga cuidado al instalar las baterías, oriéntelas con el lado positivo hacia su izquierda cuando este de frente al dispensador).
Note: If batteries are loaded incorrectly, the unit will not function. (Nota: Si las baterías son instaladas incorrectamente, el unidad no funcionará.)
Rechargeable
Recargables NiCad
BATTERY LOADING:
