San Jamar EZ-Fit Lid L2200C Manual

Note: EZ-Fit® Lid Dispensers are intended for use with flat, cold beverage lids only. This product is not designed for use with domed
lids or most contoured hot beverage lids. For best performance, test lid compatibility prior to installation.
The L2200C EZ-Fit® Lid Dispenser is designed for use with lids up to 3.75” in diameter. For larger lids, please use the L2400C EZ-Fit®
Lid Dispenser.
EZ-Fit® Lid L2200C
Lid Dispenser Instruction Guide
Thank you for purchasing the EZ-Fit® Lid Dispenser from San Jamar. EZ-Fit® Lid is designed to provide simple, sanitary lid dispensing
that is easy and convenient for both you and your guests. If you have any questions or comments, please do not hesitate to contact us
at www.sanjamar.com or [phone].
IN-COUNTER MOUNTING INSTRUCTIONS
47/8”
124mm
1. Cut hole in counter surface.
4. Replace trim ring with lid dispenser door assembly by
turning clockwise.
2. Remove trim ring with lid dispenser door assembly
attached by turning counterclockwise.
3. Insert dispenser tube into
counter and secure mount
ring to counter with screws
provided (#8 screws).
5. Rotate lid dispenser door assembly (a) to desired
orientation (b).
ab
LOADING INSTRUCTIONS
1. Open lid dispenser door by pressing
down on top of door assembly (a) and
pulling outward (b), releasing door latch.
a
b
2. Load full sleeve of lids, assuring that inside of lids are facing
outward, as shown.
3. While holding lids in place, close lid
dispenser door, snapping latch securely
in place.

555 Koopman Lane • Elkhorn, Wisconsin 53121 USA
Customer Care: 800.248.9826 • T: 262.723.6133
F: 262.723.4204 • www.sanjamar.com ©2006 San Jamar 100768
Lid Door Cover
Item #: 100662
Push Plate
Item #: 100664
Mount Ring
Item #: X22MT
Lid Holder
Item #: 100663
Trim Ring
Item #: X22TR
REPLACEMENT PARTS
Patent Pending
Tips for Best
Dispensing Performance
1. Be sure lids are always loaded with the top
side of lid loaded first, with inside of lids and
lid flanges facing outward, as shown in loading
instructions.
2. EZ-Fit® Lid is designed for use with flat,
cold beverage lids only. Dispenser may not
dispense properly if using contoured hot
beverage lids or domed lids.
3. Some brands and styles of beverage lids may
dispense better than others, due to the tightly
nested nature of the lid stack. For best results,
test lid performance before use.
Item No. Description Lid Rim Dia. Approx. Size
L2200C Small Lid Dispenser 2.75” to 3.75” 8oz. to 24oz.
L2400C Large Lid Dispenser 3.75” to 4.75” 24oz. to 64oz.
EZ-FIT® LID DISPENSER PRODUCT LINE