
SCHAFFERT MFG. CO. INC. - phone: 800-382-2607 - fax: 308-364-2410
REBOUNDERTM MOUNTING INSTRUCTIONS
John Deere 750/1560/1590/1690/1860/1890/1990 Drills
(Read Instructions Completely before Beginning Installation)
DANGER:
When storing or working on the drill always install cylinder stops or place the drill on stands to prevent personal injury or damage to the Rebounder.
WARNING:
Do not roll back or back up the drill in or on the ground as this can result in damage to the Rebounder.
Before working on your planter or drill
Rebounder Mounting Instructions
Before you begin, verify all items listed in the “package contents” table at the right.
Step #1: Remove the 1/4″ bolt and washer holding the seed apper in place on the seed boot of
the John Deere drill. Now you are ready to mount the Rebounder in the place where the
John Deere seed apper was.
Step #2: Place the Rebounder in the bottom of the seed boot as shown below. Raise the press
wheel and let it rest on the square collar. Place the 1/4 x 7/8” whiz bolt through the
Rebounder and tighten it into place.
Rebounder covered by one or more of the following U.S. patents: 5,640,915; 5,918,557; 6,082,275; 6,283,050; 6,453,832; 6,763,773 and 7,121,216.
71495 rd. 397 - indianola, ne 69034 - phone: 800-382-2607 - fax: 308-364-2410 - sales@schaffert.com - www.schaffert.com - 26 aug 2014
John Deere
seed boot Rebounder
Rebounder Packa
g
e Contents
(per sin
g
le row)
Item Quantity
Rebounder ....................... 1
1/4″ x 7/8″ Whiz Bolt ............... 1
Instruction Sheet .................. 1
Whiz bolt