Screen Technics CinemaSnap Series User manual

1
CinemaSnap Projection Screen &
Installation Instructions
Thank you for purchasing a Screen Technics Projection Screen, please ensure that you read
the following instructions fully before attempting to install this product.
Step 1. Layout all components ready for assembly as shown below.
Step 2. Push the four corners of the frame together. You may need to use a plastic or
wooden mallet (not metallic) to achieve this result.

2
Step 3. With the Hex Head Allen-Key screw use the provided Allen-Key to screw tight all
four corners. You must ensure each of the four corners are square and there are
no large gaps obvious before you start to insert Hex head Allen-Key screw,
otherwise jamming may occur.
Step 4. Tighten all internal Allen-Key screws (one on each corner as shown below),
before fully tightening the external screws.
Step 5. It is now time to install the L-Shaped brackets and there are two options:
• The brackets come supplied with self tapping (Tek) screws that allow you to drill directly
into the frame, anywhere that best suits wall stud supports and the like. Latter on in the
installation you will need enough room to re-screw these Tek screws top and bottom of
the frame for final fixing.
• If you don’t have enough “elbow” room to get at the top of frame with a power or screw
driver at this latter time because of a low ceiling then utilize the nylon bushes supplied
with the small Allen-Key bolt and fix one each to the two top L-Brackets and use the
two locating holes on the top of the frame, although this restricts bracket positioning it
allows you to simply insert the bushes into the holes and then fix the bottom brackets
by screws and your done.

3
Step 6. Attach brackets as shown – Utilizing nylon bushes and locating holes only if
necessary as explained in previous step.
Step 7. With all four brackets attached, place screen frame (not with surface) on the wall
and mark holes.

4
Step 8. Use wall mates or plugs to attach frame if no wall studs are present and
ensure that you have a secure fixing method for a safe installation.
tep 9. Remove frame from the wall by undoing outside bracket screws - Brackets are to
remain on wall.
Prepare screen surface
Please do not allow the steel rods to come into contact with the screen surface viewing area
as it may cause damage.
Step 10. Place all four steel rods into the sleeve surrounding the screen surface.

5
Step 11. Once all four rods have been placed into the screen sleeve, attach the screen
surface to the frame as shown below - ensuring to work the screen surface
evenly to all four sides.
Step 12. Once all four sides of the screen surface have been placed evenly, the screen
surface should be attached to the frame as shown below. Now you are ready to
install.
Step 13. Attach the screen to the brackets on wall – Wipe down screen frame of any
fingerprints and dust off the screen surface.

6
Please follow these instructions to ensure trouble free operation;
• Cleaning of the screen is best achieved by first dusting the surface with a feather
duster, then to remove any stubborn marks, use a small amount of mild detergent and
warm water on a clean white lint free cloth. It is most important that you only treat the
actual mark by this process and not the entire surface. Do not use any abrasive
cleanser as this will damage the surface.
Should you have any questions regarding the installation of our projection screens please call
our technical sales desk on 02 4869 2100 for assistance.
Cnr Vale & Suttor Roads
Moss Vale
NSW 2577
PH – 02 4869 2100
Fax – 02 4869 2123
Thinking Screens… Think Screen Technics