Sealey AP1100M User manual

INSTRUCTIONS FOR:
MOBILE WORKBENCH 2-LEVEL
MODEL NO: AP1100M
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.
Locate bench in a suitable working area.
 Keep the work area clean, uncluttered and ensure there is adequate lighting.
WARNING! Use bench on level and solid ground, preferably concrete. Avoid tarmacadam since the bench may sink into the surface.
Always apply the brakes to the locking castors before using the bench.
Keep the bench clean and tidy in accordance with good workshop practice.
Keep children and unauthorised persons away from the working area.
 DO NOT place heavy loads on the lower shelf.
 DO NOT use the bench for any purpose other than that for which it is designed.
DO NOT carry out any work on the bench without the workpiece being adequately secured. Use clamps or a vice (not included) to secure
the workpiece (available from your Sealey dealer).
 DO NOT use the bench outside.
 DO NOT get the bench wet, or use in damp or wet locations or areas where there is condensation.
 DO NOT clean the bench with any solvents which may damage the paint surface.
WARNING! This workbench is heavy and assistance should be obtained before assembly.
2. INTRODUCTION
Sturdy steel construction workbench with a capacity of 300kg. Two shelves that allow unobstructed access. Fitted with two xed castors, two
locking castors and a heavy-duty handle.
3. SPECIFICATION
Model No: .............................................. AP1100M
Size incl. Handle (W x D x H): .......................1180 x 700 x 830mm
Work Surface (W x D): ..................................1100 x 700mm
Capacity: .................................................. 300kg
AP1100M Issue: 1 - 05/11/15
© Jack Sealey Limited Original Language Version

4. ASSEMBLY
Key:
1: Bench Top
2 Leg Frames (x2)
3: Support Brackets (x4)
4: Castor Brackets (x4)
5: Locking Castors (x2)
6: Fixed castors (x2)
7: Handle
8: Shelf
g.1
4.1. Place the bench top (g.1.1) upside on the oor. Use a oor covering to protect the
bench top.
4.2. Fasten the four support brackets (g.1.3) to the leg frames using the xings
provided (g.2).
4.3. Fasten the leg/bracket assemblies to the channels welded to the underside of the bench
top (g.3).
4.4. Fasten the four castor brackets (g.1.4) to the legs.
4.5. Fasten the two locking castors (g.1.5) to the legs at one end.
4.6. Fasten the two xed castors (g.1.6) to the legs at the other end.
4.7. Fasten the shelf (g.1.8) to the crossmembers of the leg frames.
4.8. Using two people, turn the bench right way up.
4.9. Fix the handle (g.1.7) to the end of the bench to which the locking castors are tted.
g.2
g.3