Silhouette 5541 Owner's manual

TMA –The Icon Technical Instructions
Model 5541

Glazing | TMA –The Icon
Frame is designed with a 5.0 base curve
Other lens base curves can be used and will require bridge
adjustment
Recommended lenses are High Index 1.6, 1.67, Polycarbonate
and Trivex
Use Silhouette pliers with gray or purple tip and BLS 58
sleeve for mounting
OMA shape files and drill coordinates are available at:
https://portal.silhouette.com
www.silhouettelab.com
Patterns available from Silhouette Customer Service at 800-
223-0180

Inclination | TMA –The Icon
2. Bend the temple in the
required direction
1. Support temple and lens
mounting with mounting pliers to
prevent stress on lens mounting

Te m p l e opening | TMA –The Icon
Hold lens fixation firmly with your fingers and use
the Blue multi-tool to enlarge the temple opening

Te m p l e closing | TMA –The Icon
Hold lens fixation firmly with your fingers
and use the Blue multi-tool to reduce the
temple opening

Te m p l e s h o r t e n i n g n o n -glued | TMA –The Icon
Pull off temple end

1. Shorten titanium wire with metal-diagonal cutter
2. File down sharp edges and burrs
Te m p l e s h o r t e n i n g n o n -glued | TMA –The Icon

Te m p l e s h o r t e n i n g n o n -glued temple I TMA –The Icon
Squeeze titanium wire with round pliers at the very end
to ensure the stability of the temple end and reinstall
temple cover

Adjusting temple end | TMA –The Icon
Adjust the temple to the ear shape with large curves.
During temple-end adjusting do not put pressure on the
temple tip

Additional Information | TMA –The Icon
Clean with ultrasonic bath or with ethanol/ethyl alcohol.
These methods will not damage the frame.
Lenses with AR coatings could be damaged in ultrasound
bath. Use caution with these lenses.
Always store your frame in the supplied case.