Friant ZONE CLASSIC FRI-BJ-MM2333M User manual

ZONE CLASSIC
SEATING MANUAL
4901 EAST 12th St / Oakland / California 94601 / T: 510.535.5113 / F: 510.535.5237 / friant.com
USER GUIDE
FRONT VIEW
Backrest can be pulled up and down. Raise the
backrest to the top position when you would
like to adjust it to the initial position
Turn this button to adjust the
up and down of the seat. Pull
the handle to release the back
tilting lock or unlock function
Press this button to
adjust the up and
down of the armrest
The lock button can adjust
the armrest width

4901 EAST 12th St / Oakland / California 94601 / T: 510.535.5113 / F: 510.535.5237 / friant.com
ZONE CLASSIC
SEATING MANUAL
ASSEMBLY GUIDE
Item Parts Qty.
A Back Assembly 1
B Seat Assembly 1
C Mechanism 1
D Armrest L/R 1
E Gas Lift 1
F Base 1
G Caster 5
H Adjusted Width Button 2
Item Parts Qty.
IInner Hexagon Screw
5/16” x 3/4” 3
JFlat-head Inner Hexagon Screw
1/4” x 7/8” 4
KFlat Pad
16 x 8.3 x 2.0mm 7
LWrench
M5 - 25 x 64 1
M Dust Cover 1
NOTE: Carefully check all parts according to the instructions
before assembling. Please assemble carefully to avoid
scratching surfaces, especially powder-coated surfaces.
Parts & Hardware

4901 EAST 12th St / Oakland / California 94601 / T: 510.535.5113 / F: 510.535.5237 / friant.com
ZONE CLASSIC
SEATING MANUAL
ASSEMBLY GUIDE
1. Assembling the Caster & Base
Insert five casters [G] into the base [F].
Push hard until you feel or heard the cast-
er snap into place.
4. Assembling the Seat & Back
Keep the seat assembly [B] on a table plane
first, then insert the back assembly [A] into
the seat assembly. Be sure all three holes are
in the right place, then fix the seat assembly
with inner hexagon screw [I] and flat pad [K]
by wrench [L].
5. Assembling the Armrest & Seat
Insert the lower part of the armrest [D] into
the seat assembly [B] then lock it with the
adjusted width button [H]. 5. Assembling the Seat & Gas Lift
Insert the seat assembly [B] into the gas lift [E].
2. Assembling the Base, Gas Lift & Dust Cover
Insert the gas lift [E] into the base [F], then put
the dust cover [M] on the gas lift.
3. Assembling the Seat Assembly & Mechanism
Keep the seat assembly [B] on a table plane
first. Then insert the mechanism [C] into the
seat assembly. Be sure all four holes are in the
right place, then fix the flat-head inner hexagon
screw [J] and flat pad [K] into the seat assembly
by wrench [L].

4901 EAST 12th St / Oakland / California 94601 / T: 510.535.5113 / F: 510.535.5237 / friant.com
ZONE CLASSIC
SEATING MANUAL
PRODUCT DIMENSIONS