Solo 453 User manual

9 453 100 03/2013
453
Originalbetriebsanleitung
Gebrauchsanweisung
Translation of the original
instructions
Instruction manual
Traduction de la notice originale
Instructions d'emploi
Traducción del manual original
Manual del usario
Traduzione delle istruzioni originali
Istruzioni d'impiego
Vertaling van de oorspronkelijke
gebruiksaanwijzing
Gebruiksaanwijzing
Druckspritze
Pressure Sprayer
Pulvérisateur à pression
préable
Pulverizadora de présion
Pompe ad alta pressione
Drukspuit
Achtung!
Lesen Sie vor der ersten Inbetriebnahme
diese Gebrauchsanweisung gründlich
durch und beachten Sie unbedingt die
Sicherheitsvorschriften!
Attention!
Read this instruction manual carefully before
first operation and strictly observe the safety
regulations!
Attention!
Lire attentivement le présent manuel avant la
première mise en service et observer
impérativement les consignes de sécurité !
Atención!
¡Lea atentamente este manual de empleo
antes de la primera puesta en
funcionamiento y respete imprescindiblemente las
prescripciones de seguridad!
Attenzione!
Prima della prima messa in funzione leggere
a fondo le presenti istruzioni per l'uso e
osservare assolutamente le norme di sicurezza!
Attentie!
Lees vóór de eerste inbedrijfstelling deze
handleiding zorgvuldig door en let
absoluut op de veiligheidsvoorschriften!

Fig. 2
Fig. 6
Fig. 1
Fig. 7
Fig. 3
Fig. 4 Fig. 5

- ENGLISH –
The following symbols are used in these operating
instructions and on the device itself:
Caution
Refer to the operating instructions
Wear protective clothing
Wear protective gloves
Wear face protection
A breathing mask should be worn when
using poisonous chemicals
Maintain a minimum distance of 15
metres bystanders
Safety directives and general instructions
Compliance with this safety manual is a
prerequisite for proper operation of the sprayer.
The pressure sprayer must be checked before
each use.
This pressure sprayer is suitable for applying
approved liquid plant protection, insecticides,
and weed killing substances, as well as liquid
fertilizers that are available from authorized
dealers. We recommend using only plant
protection substances that are approved by the
German BBA (German Federal Biological
Institute).
The sprayer must be cleaned when changing the
spray substance. This avoids possible chemical
reactions.
Do not use liquids over 40°C.
Due to bodily hazard, only the abovementioned
liquid substances may be applied with this
sprayer. Disinfectants and impregnation
substances may not be used.
Never leave the filled and /or pressurized
pressure sprayer unattended for longer periods.
For safety reasons, children, young people
under the age of 16, and persons that are not
familiar with these operating instructions, may
not use this pressure sprayer.
The pressure sprayer must be kept out of the
reach of children.
The user is responsible relative to third persons.
The pressure sprayer must be de-pressurized
before disassembly of any component, and
before opening the pump, by pulling on the
pressure valve (Fig. 3)! Before pulling on the
pressure valve, the sprayer must always be in an
upright position. Attention: keep the sprayer
away from your face!
Do not expose the pressure sprayer to high
temperatures.
Malfunctions of any kind, such as, for example
leaks at the tank, spray pipe and tubing,
signs of damage, cracks, etc.,
other irregularities,
is the syringe immediately make pressure on the
safety valve. The sprayer must not be reused, but
must be checked by a qualified person.
The manufacturer was not aware of any harmful
effects on the product materials caused by plant
protection substances at the time the product was
manufactured.
Assembly
Firmly screw the spray tube with O-Ring (16x3
mm) onto the shut-off valve. In the process, -fasten
the threaded collar (Fig. 1, Pos.1) on straight and
firmly tighten it by hand – do not use force and do
not use any tools to firmly fasten the collar!
Fig. 2: When your work is completed, the spray
tube should be fitted into the holding clamp.
The pressure sprayer can also be carried by the
pump handle, if the pump handle is pressed down
completely, and it is turned to the right and clicked
into position.
Placing in service
The pressure sprayer must be de-pressurized
before disassembling any component, and before
opening the pump, by pulling on the pressure valve
(Fig. 3)! Before pulling on the pressure valve the
sprayer must always be in an upright position.
The pump must be removed to fill the spray liquid.
To do this, push the pump handle down and turn it
to the left (counterclockwise) until the handle clicks
into position.
Fig. 4: Unscrew pump by turning it counter
clockwise. Do not use any tools!
Fill the spray liquid to the fill mark maximum.
Model 453: 11 liters
In this regard, follow the safety directives and
insure the correct dosing according to the
instructions provided by the manufacturer of the
spray substance!
Thoroughly mix the liquid, insert pump and refasten
firmly by turning clockwise. Firmly tighten by
turning pump handle clockwise until it clicks into
position.

- ENGLISH –
Spraying
The pressure sprayer must be de-pressurized To
pump, loosen the pump handle by turning out of
the stop position.
Fig. 5: Pump the unit until the operating pressure
is reached in the container. Excessive pressure
escapes automatically through the safety valve.
Take the spray tube in your hand and start the
spray process by pressing the shut-off valve.
Releasing the shut-off valve stops the spray
process.
Fig. 6: Nozzle adjustment
a) Closed hollow cone
Delivery rates 2 bar: 0.45 l/min
_________________________________
b) Open max. 360° coarse and narrow
Delivery rates 2 bar: 0.70 l/min
The spray tube can be rotated in the shut-off valve
– after loosening the threaded collar – this is
useful for spraying under leaves.
Cleaning, care and storage
After each use, release pressure, always keeping
the sprayer in vertical position. Empty the
container, carefully clean, and rinse well with clean
water. Do not empty residual quantities of spray
liquid into watercourses; rather dispose of them via
communal disposal systems.
For cleaning nozzle, spray tube, and shut-off valve,
operate the sprayer using clean water (add
dishwashing detergent if required).
Fig. 7: Occasionally clean the filter and spray
nozzle with water and a soft brush. Never use your
mouth to blow through the spray nozzle!
Never use aggressive, acidcontaining, solvent-
containing cleaning substances (gasoline for
example).
Always empty the sprayer completely and store it
in a location that is dry, frost-free, and protected
from direct sunlight.
Technical data
Maximum fill volume 11.0 l
Tank capacity 13.5 l
Permissable operating pressure 2 bar
Permissable operating temperature 0ºC - 40ºC
Mesh width of filter screen
in spray tubing 0.8 mm
Max. Delivery rates 2 bar: 0.70 l/min
Weight empty 3.370 kg
__________________________________________
In the best interest of continued technological
progress we reserve the right to change the design
and configuration of any product without prior
notice.
For that reason, no claims can be accepted with
reference to text and illustrations in this manual.

DEUTSCH
1 Spritzrohr
2 Sicherheitsventil
3 Pumpengriff
4 Spritzdrüse
5 Handventil
6 Behälter
ENGLISH
1 Spray tube
2 Safety valve
3 Pump Handle
4 Spray nozzle
5 Shut-off valve
6
Container
FRANÇAIS
1 Lance
2 Soupape de sécurité
3 Poignée de pompe
4 Buse
5 Valve à gâchette
6 Réservoir
ESPAÑOL
1 Tubo atomizadora
2 Valvulva de seguridad
3 Empuñadura de la bomba
4 Tobera atomizadora
5 Grifo de cierre
6 Depósito
ITALIANO
1 Tubo irrorazione
2 Valvola di sicurezza
3 Impugnatura pompa
4 Ugello irrorazione
5 Valvola manuale
6 Contenitore
NEDERLANDS
1 Spuitstok
2 Veiligheidsventiel
3 Pompgreep
4 Spuitdop
5 Hand ventiel
6 Reservoir
SOLO
Postfach 60 01 52
D 71050 Sindelfingen
Tel. [phone]
Fax [phone]
[email protected]
SOLO
P.O.Box 60 01 52
D 71050 Sindelfingen
Germany
Phone[phone]
Fax [phone]
[email protected]