Sony PCS-HG90 User manual

Revolabs Single Channel System — Sony PCS-HG90 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Sony PCS-HG90 video codec.
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Sony PCS-HG90 video codec
3. QTY 1 07-STEMIC-PPP Line-to-Mic Adapter Cable*
* Optional Item

Connecting the Cables
1. Connect the 07-STEMIC-PPP Line to Mic adapter cable to the 2.5mm AUDIO
port on the Single Channel System
2. Connect the XLR male connector on the 07-STEMIC-PPP cable to the left MIC
port on the Sony PCS-HG90. Disregard the RCA portion of the 07-STEMIC-PPP
cable.
1. Push the TOOLS button on the remote control
2. Select SETUP
3. Select AUDIO to MIC
4. Select CTE to OFF
5. Select ECHO CANCELLER to ON
6. Save settings
Configuring the Sony PCS-HG90 Video Codec
1