SRC BMW R1200 GS User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-R1200GS-13-01-SL / BMW-R1200GS-13-02
Part Description: KICK STAND SENSOR GUARD –BMW R1200 GS
Installation / Parts List / Bill of Material for Mounting
The scope of supply for the above is the Sheet Metal Guard and 2 off Cable Tie, as shown in the
drawing.

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
Step: 1
Unscrew the OE Mounting
Bolt holding the Sensor in its
place.
The same screw will be used
for mounting the Sheet Metal
Guard.
Step: 2
Orient and Align the Kick Stand Sensor
Guard, as shown, and Slip-in the OE
screw through the Mounting hole in
the Guard and secure the threads in
the Sensor Housing, as shown in Red
Colour.
Step: 3
Lead the Cable tie –2 off, as
shown, and inserting them
into the slots in the Guard, tie
it around the Stand stem.
SRC Kick Stand Sensor Guard
protects the, sensor, its mount
and the sensor connector, as
shown.
Final mounted condition of the
Sensor Guard is as shown.

Copyright By SRC
Design and Specification are subjected to change
Page 4
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory
part to the Vehicle. We have prepared this based on our experience and knowledge, related to
the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour a
nd/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8.To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it.
9. If any additional modifications are to be done, prior to the fitment of the accessories, it will
be explicitly specified in the instruction sheets.