SRC H-CRF300L-02-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
NO. Description Quantity Torque * (N-M) Remarks ** Chacklist
2
9-10
5- 6
2
1
1
1
1
2
1
2
3
4
5
6
7
Radirtor Guard
Screw M6x25
Screw M5x16
Hex flange nut gradea M5
Rubber Tape
Washer M6
Washer M5
SRCDesign uses MetricSystem of Measurement and all dimensions in Millimeters
*Recommended to use the Torque specified in the table
**Denotes Usage of Liquid Thread Locker in specified Locations
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-CRF300L-02-01-SL / H-CRF300L-02-02
Part Description: Radiator Guard –HONDA CRF300 L
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
Step 4:
Align the Dirt Shield, as shown, in-line
with the Mounting holes and slip-in
the original Screw and original pin in
motorbike (as show) and secure the
threads and tighten it fully.
Mounting Instructions
Step 1:
Remove the original screws, pin,
and remove the original guard
before starting to mount SRC
Radiator Guard (as show)
Step 2:
Orient the Radiator Guard (1)
and Slip-in the washer M6 (3)-2
off, Screw M6x25 (2)-2 off,
(Shown in “Red” colour), which
holds the Radiator to the Chassis
frame through and secure the
threads, and tighten it fully.

Copyright By SRC
Design and Specification are subjected to change
Page 3
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8.To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9.If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.