SRC R-HM22-28-02-L User manual

:
Installation / Parts List / Bill of Material for Mounting
:
1
2
NO. Description Quantity Torque*(N-M) Remarks**
10
Use Liquid Thread Locker
SRC Design uses Metric System of Measurement and all dimensions in Millimeters
Recommended to use the Torque specied in the table Denotes Usage of Liquid Thread Locker in specied Locations
HIMALAYAN 410 2022
11
LH - oil tank bracket
Socket button head screw M5x25mm
Washer M5
Rubber Sheet
AD-PART-OIL-Tank-01
BLACK CABLE TIE
Oil-Tank-2
Oil-Tank-3
Oil-Tank
Hex ange nut gradea M5
Nut plate
copyright By SRC
Design and Specication are subjected to change
5-6
R-HM22-28-02-L

copyright By SRC
Design and Specication are subjected to change

copyright By SRC
Design and Specication are subjected to change

copyright By SRC
Design and Specication are subjected to change
Mounting lnstructions
2
3
4
5
7
11
10
1
Put parts
(socket button head screw m5x25mm)
and parts(washer m5)
on parts( LHorRH oil tank bracket).
Assemble the parts as shown in the picture.

copyright By SRC
Design and Specication are subjected to change
1
1
6
Bring (Black cable tie)
to attach to the motorcycle.
take the assembled parts Comes
assembled with the original place as
shown in the picture.
Remove the original parts from
the motorcycle.

copyright By SRC
Design and Specication are subjected to change
9
8
Check and check the tightness of the
assembled parts.
Take the fuel tank in and
after that use the ( oil-Tank-3)
dial to t it rmly in your hand.

1. We request you to pay attention to the Mounting Instructions in this document and follow the step-by-
step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) tment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all functions of
the Vehicle. It is always advised to check loosening of the fasteners after the rst 50 kilo meters of ride and
at regular intervals.
7. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not aect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
8. If any additional modications are to be done, prior to the tment of the accessories, it will be explicitly
specied in the instruction sheets
copyright By SRC
Design and Specication are subjected to change